Date
1 - 3 of 3
Locked TS 2000 SignaLink, Flrig, & WSJT-X ver. 2.5.4 #Kenwood
|
Felix Barndt
I am trying configure my almost new Kenwood TS-2000 to work with Flring v. 1.4.7.49 , SignaLink with their Kenwood data cable, and WSJT-X v. 2.5.4. (Fligi works fine so there are no cable issues). From what I have been reading on this forum, I assume the correct PTT setup is to use VOX and USB . At one point in time things were kind of working. The Tune button worked every time, however, the Enable Tx button would work for a few times and then quit. Then it would start working again and then quit. Should I use no radio control or should I use a different program to control the radio? I am not quite sure how to proceed. I have been searching through topic on this forum.
Thanks in advance for the help! Felix KF7LB |
|
|
|
Tim Dawson
Signalink for audio, and WSJT-X with Hamlib (native) for rig control (freq, etc. as well as PTT for most, if desired). The SignaLink is a nice unit, but it is audio only . . .
toggle quoted message
Show quoted text
If you are running PTT via the SignaLink VOX, make sure that the power slider in WSJT-X is not turned dow, since that reduces audio level, and may drop you below the VOX threshold. On November 22, 2022 6:49:32 PM EST, ic2118@... wrote:
I am trying configure my almost new Kenwood TS-2000 to work with Flring v. 1.4.7.49 , SignaLink with their Kenwood data cable, and WSJT-X v. 2.5.4. (Fligi works fine so there are no cable issues). From what I have been reading on this forum, I assume the correct PTT setup is to use VOX and USB . At one point in time things were kind of working. The Tune button worked every time, however, the Enable Tx button would work for a few times and then quit. Then it would start working again and then quit. Should I use no radio control or should I use a different program to control the radio? I am not quite sure how to proceed. I have been searching through topic on this forum. --
Sent from my Android device with K-9 Mail. Please excuse my brevity. |
|
|
|
Felix Barndt
Tnx for the info.
When I click on the Enable TX button and a message is sent, should I then be able to click on the button again and immediately send another message? Or is there some kind of built in delay governing how quickly I can send another message? Sometimes I can click the button quickly in succession and messages are sent, other times I have to wait for the Enable TX button to work. This is the issue that is bugging me. I have never used the WSJT-X program before. Felix KF7LB |
|
|