Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows

From: John Sexton<mailto:bubafish@...>
Sent: Sunday, September 4, 2022 2:00 PM
To: main@WSJTX.groups.io<mailto:main@WSJTX.groups.io>
Subject: WSJTX working fine under N1mm Logger but not stand alone #TxaudioIssues #Yaesu


#txaudioissues
#rigblasterpro
#yaesu
#audioissues



Hi all, I’m cross posting this as it touches both programs. I’m a total noob when it comes to FT 8/FT4 did a bit of JT65 back when I lived in RI. Station is small here Northern Maine. But, I seem to able to make contacts with FT8 run under N1MM logger. But with the Stand alone wsjt-x I have had no luck. The Radio is a Yaesu FT1000mp interface is good ole Rig Blaster Pro. Working fine for CW and Rtty. Receive is fine so I wont trace out the audio out from the radio. The audio into the radio comes from Speaker out and into the Rig blaster and into the front mike jack. The only difference I can see is in the Stand aloneby the keying is by the native com port. The N1mm logger ptt is Via rig control. The odd item is with the rig blaster With the stand alone I get full audio out. With N1MM I get no power out unless I switch the processor switch on the Rig blaster. If the situation was reversed then I would understand. But I am making contacts with stations (usually Loud ones) from within N1MM calling WSJTX. But with the stand alone I don’t seem to be heard by the +s or the –‘s Any suggestions would be welcome

73
John KO1H FN67
Van Buren ME


Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows