Hello friends
After setting up 2.4.0-rc1 - which went fine - I first time used the [Configurations] Tab, where one may save an actual setup.
This has its "special" philosophy", but one understood, you see the good thing.
All is working well, except it does not save the selected band, at least not, if a transceiver is connected - in my case Kenwood TS590s. It simply forgets the band setting. I saved something like 50 - FT8 and when switching to 7 - FT4 it switches to FT4 but stays on 50 MHz.
I made a complete different setup for a remote operation EME1296 - JT65C, where there is no TRX connection (via USB or Virtual COM ports), it remembers the band.
This is not a priority thing, but a nice to have issue.
73 and see you on the bands
Christoph DF9CY

Hello friends
After setting up 2.4.0-rc1 - which went fine - I first time used the [Configurations] Tab, where one may save an actual setup.
This has its "special" philosophy", but one understood, you see the good thing.
All is working well, except it does not save the selected band, at least not, if a transceiver is connected - in my case Kenwood TS590s. It simply forgets the band setting. I saved something like 50 - FT8 and when switching to 7 - FT4 it switches to FT4 but stays on 50 MHz.
I made a complete different setup for a remote operation EME1296 - JT65C, where there is no TRX connection (via USB or Virtual COM ports), it remembers the band.
This is not a priority thing, but a nice to have issue.
73 and see you on the bands
Christoph DF9CY

Hi Christopher,

switching to a new configuration in WSJT-X is basically the same as restarting WSJT-X. Whether WSJT-X recalls the last used frequency when starting is determined by the "Settings->General->Monitor returns to last used frequency" option. Check that option in each configuration where you want the last used frequency to be recalled.

73
Bill
G4WJS.