Date
1 - 6 of 6
Locked UHF / SHF frequencies #WSJTX_config
|
dk1vi
Hi,
I am using version 2.2.0. My problem: the UHF / SHF frequency as defined in Settings -> Frequencies can not be selected in WSJT main window. Only frequencies up to 144MHz are availabe. VHF features are enabled. Any ideas? 73 Ernst |
|
|
|
On 26/12/2020 14:10, dk1vi wrote:
Hi,Hi Ernst, no one else has reported such an issue, are you sure you are entering the frequencies correctly in MHz? 73 Bill G4WJS. |
|
|
|
Joe Dz
Ernst,
After you input the frequencies into the frequency list, did you select the OK to save them? That got me a long time ago. Hi hi.
I am using WSJT-X with a IC-9700 just fine on 432 and 1296.
Joe, K1YOW
From: main@WSJTX.groups.io [mailto:main@WSJTX.groups.io]
On Behalf Of dk1vi
Sent: Saturday, December 26, 2020 9:11 AM To: main@WSJTX.groups.io Subject: [WSJTX] UHF / SHF frequencies #WSJTX_config
Hi, |
|
|
|
Jim Bacher - WB8VSU
At the VHF + frequencies you have to add them to the frequency list in settings before they show up in the main screen list.
Jim Bacher, WB8VSU
wb8vsu@...
On Dec 26, 2020, at 10:43 AM, dk1vi <dk1vi@...> wrote: Hi, |
|
|
|
g3wdg <charlie@...>
Hi Ernst
toggle quoted message
Show quoted text
Are you in FT8 mode? If so, the frequency table by default only has FT8 frequencies up to and including 144MHz. In other modes, eg JT65, JT4, QRA64 you should have frequencies available above 144. You have the option to add frequencies/modes etc to the frequency table as you need them. 73 Charlie G3WDG Hi, |
|
|
|
dk1vi
Thanks to all who replied.
Charlie gave me the solution: mode was set to FT8. If have been using FT8 in recent years on SW and JT65 on EME. But I was not qrv for some years becaus lack of antenna(s). Now my only antenna is a 1,2m dish for 23cm, Running ~90W will try to make some tests and DX in QRA64 and SSB when propagation is enhanced. So I have to refresh my skills and learn again. Regards Ernst |
|
|