On 21/09/2015 13:37, David Michael
Gaytko // WD4KPD
wd4kpd@... [WSJTX] wrote:
Hi David,
Ahoy there mates....
should like to know you rig settings in wsjt-x for my
FT-920, especially
the Mode and Split settings. Using VOX/Signalink for key.
I am aware of an issue using DX Lab Suite Commander as a rig control
intermediary with WSJT-X and the FT-920. Otherwise it works as
expected. If you wish to use JT9+JT65 mode then I recommend setting
the mode in WSJT-X as "None" and "Split Operation" as "Rig.
The WSJT-X "Mode" has to be set to "None" so that WSJT-X doesn't not
attempt to set the rig mode. The reason for this is that you
probably need to set the rig to LSB+DATA on both VFOs (also set the
switch on the back to AFSK). You will also need to set the menu item
U-46 (PKT-FRQ) to 1170-U and then set menu U-45 (PK-DISP) to 0.000
(the order is important).
The "PTT Method" should be "VOX" for the SignaLink USB, leave the
rig on normal PTT.
The rig bandwidth maximum is ~2.7kHz so you will need to adjust the
IF shift to focus on parts of the 4kHz wide JT9+JT65 sub bands.
The most annoying (mis)feature of this rig, apart from the perverse
LSB mode for USB data operation, is that the MIC GAIN control is
active when in DATA mode with audio from the rear accessory socket.
So you need to set your DATA Tx modulation level with the MIC GAIN
set to your normal SSB speech setting and leave it there.
david/wd4kpd
--
God's law is set in stone...everything else is negotiable.
73
Bill
G4WJS.
