Ok as an update, as I owe this community a lot of grattitutde. Heres the lay down of the story. 1. Got an old TS-450 I wanted to play with on FT8. 2. Bought an XGGCOMMS digimode -4 cable. 3. Got the c

#WSJTX_config #Windows10 #ftdi #Kenwood

Yups I wrote an email to xggcomms about this, and Ui need to figure out also a way to cancel the possibility of my RIG as the source of errors. Thanks for the help Mike! P.S. have deleted my other rep

#Windows10

Hi Chris, Im having the same struggle here, was able to get WSJTX working but there is no control on RIG (TS-450). I set the rig manually to the freq and do the work around, still wishing I could get

#Kenwood #Cat_RigControl

ok im sorry if im all over the place as sometimes I answer back using my android via email. Just an update of what Im doing and whats currently being learned :). Hardware: Rig: Kenwood TS-450 Cable: x

#WSJTX_config #Windows10 #ftdi #Kenwood

Hi Mike, Yups I only use the XGGCOMMS cable, what I meant to say to Eric was that, the XGGCOMMS cable mimics the IF232 as seen on Fprog if you probe the FTDI chip. BTW I will be setting up anydesk and

#WSJTX_config #Windows10 #ftdi #Kenwood

Hi Eric, Current connectivity setup is using XGGCOMMS digimode 4, Theres two male plugs one is setup at the back ACC2 with 13 pins i think, and the other is connected at the side which is the ACC1 ser

#WSJTX_config #Windows10 #ftdi #Kenwood

No worries @Eric, Yups I read on the groups and on the service manual the serial settings for the rig, unfortunately I dont have the original cable and the defaul setting of 4800 baid rate didnt work

#WSJTX_config #Windows10 #ftdi #Kenwood

Arrgh was too eager to repy, my previous reply was incomplete. (sorry admin) 1. Yes IF 232 using xggcomms digimode 4 cable 2. Yes, I used FLDIGI, HAmlib, FLRIG, Ham radio deluxe and manual rigctl comm

#WSJTX_config #Windows10 #ftdi #Kenwood

Hi Bill, Its the CAT control that doesnt work, Im geeting cannot retrieve frequency from radio, current rig control on flrig setting doesnt move the frequency on the TS450 device/radio. What I did jus

#WSJTX_config #Windows10 #ftdi #Kenwood

Yes sir, I actually was in touch with the tech from xggcomms which is great, its just that the errors are on the software and my rig is old TS-450s and is tagged as obsolete with Kenwood. Have to surv

#WSJTX_config #Windows10 #ftdi #Kenwood

Hi Bill, thanks and you are correct, seems that 38400 baud rate works on my combination. I tested each baud rate and 38400 miraculously worked. I setup FLRIG first then used the flrig with WSJTX. stil

#WSJTX_config #Windows10 #ftdi #Kenwood

Hi Guys, I just bought a new xggcomms usb serial cable and was trying to make my old Kenwood ts-450s work with my laptop, but unfortunately it didnt work as easily as my xiegu with CE19. Which documen

#Kenwood #WSJTX_config #Windows10 #ftdi

Hi Chris, can I ask for your configuration and settings? what OS are you using? What cable is it an FTDI? I tried rolling back to ver 2.2 but still doesnt work on my laptop. Om using the xggcomms cabl

#Kenwood #Cat_RigControl #IssueReport