Thanks Reino. Yes, to your first question, error message uploaded, Yes to CAT control. I am testing to a telescopic vertical mounted on a three plate mag mount on a 1/2 sq metre of steel with some 15f

#Icom

Thanks all for coming back. I fired up the radio this evening and all looked fine and TUNE seemed ok, but then I was checking the swr and : --------------------------- WSJT-X - IC705 -----------------

#Icom

I have wsjt-x installed on a laptop connected to an IC-705. It was working fine "yesterday" but today I am getting an error that doesn't make much sense. The waterfall has content and decodes fine, ho

#Icom

Thanks, I hadn't explored further than the readme. Terry

#stopped_working

I should have added that I have gone through the usb power settings and set them not to sleep. If I power the radio straight after a pc reboot, all works fine, but I have seen the problem occur after

#stopped_working

I like a few others have problems with my Icom rigs appearing to move/hide/etc after a period of inactivity or another USB device being switched on and WSJT-X throws an error up and a reboot of my PC

#stopped_working

Thanks for the reply Dan. To clarify, the two US stations that were received on the 7300/hf set up were echoed in the report on the vhf/uhf receive and hence both sets got reported. Luckily 20m was pr

#WSPR

I run WSJT-X on FT8 on my 7300 and 9700 simultaneously with two discreet sessions running. If I run WSJT-X WSPR on both of them I can get the receive logs matching where I appear to be getting say a 4

#WSPR

Exactly the same here (on IC-9700 and IC-7300). Updated from 2.3 to 2.5.3 and I was getting hamlib errors, installed 2.5.2 "over" 2.5.3 and all appears to be ok again. I may try Stewart's suggestion l

#general

Thanks Bill. I will try that. Kind regards - Terry

#transmit #networking

Apologies if this has been asked before. I have one copy open for my IC-9700 on VHF/UHF and the other for HF on my IC-7300. I use the call roster on GridTracker and when I double click on a station it

#transmit #networking

I notice that when I use wsjtx, the calculated bearing/azimuth figure sometimes doesn't match other sources such as QRZ.com. An example was just now to IO70 wsjtx says 259 degrees and 247 miles. QRZ 2

#bearing #bearing

I get similar if I leave the pc and the screen saver kicks in. That might be coincidental timewise, but I clear it with closing wsjtx and opening it again. I have the usb ports set to not power down t

#txaudio #transmit

I took a look in the wsjt adi file this morning (I was contesting last night and wanted to check that the re-merge had worked) and I noticed a couple of entries where there was no grid square "logged"

Thanks Mike.

Thanks Bob.

I have my IC-7300 and IC-9700 running WSJT-X at the same time and that works fine. With an IC-705 en route would it be possible to run that to monitor say 6m as the third copy? Regards - Terry

Well put JP, there should be a back up routine to a location(s)not on the PC for may of your files.. ALSO, if you are running multiple copies of WSJT (separate copies for each rig so that they can ope

The answer to the main problem was that in the 9700 settings I had: MENU/SET/CONNECTORS/USB AF/IF OUTPUT/ wasn't set to AF

My IC-7300 works well although I still can't get used to completed calls being black on green (surely green is "go"?) but there we go. I have put a better aerial onto my IC-9700 and have been looking