Robert, One last thing. Make sure you don't have any CAT sharing issues. Only one program at a time can access the enhanced COM port, unless you are using a program such as Win4YaesuSuite, which can h

#Cat_RigControl #NewUser #TechnicalHelpQuestion #transmit #Yaesu

Robert, I had a chance to get in front of my rig. I have a few last things for you to try. I have a Yaesu FTDX-3000. I have my menu settings as such: #67 DATA MODE (PSK/OTHERS) - set to OTHERS #75 DAT

#Cat_RigControl #NewUser #TechnicalHelpQuestion #transmit #Yaesu

Sorry for what may seem like a dumb question, but when you say you can’t transmit on FT-8, do you mean all WSJT-X modes? I just upgraded from 2.5.0 to 2.5.4. Wish I didn’t. There’s a Hamlib error for

#Cat_RigControl #NewUser #TechnicalHelpQuestion #transmit #Yaesu

Is anyone running WSJT-X from within N1MM+ while using Win4YaesuSuite? I’ve tried a couple times to get it set up and get pretty far along but can’t seem to make it happen. I can run both Win4Yaesu an

#ContestMode #Yaesu #Windows10

Hi Charles, I have a Yaesu FTDX 3000 so I’m not sure if these settings will help. I spent a long time searching the internet and it took a while to get it right as everyone seems to have that one litt

#WSJTX_config

Using ver 2.2 without Omnirig. I have selected the FTDX3000 in the drop down menu in the radio tab in WSJT-X settings. This works for me - all except the split mode when I choose Rig, so I run Fake It

#WSJTX_config

Thanks Bill. I ran only WSJT-X and there was no problem. I have contacted the software engineer for Win4YaesuSuite to see what he comes up with. Thanks for your help.

Bill, Sorry for the long email. I wanted to provide as much data as I could about what I'm seeing. Thanks for the excellent response. I've been running "None" due to not knowing how things worked. I'm

I’ve been following this thread because, although I get a decent amount of QSOs, including EU, CA, and US, my signal reports are always around -20 dB. My rig is a Yaesu FTDX 3000 using CAT control wit

#FT8 #FT4

Generically, if you have WSJT-X set to forward QSOs to a logging program and then that logging program also forwards QSOs to other sites, that could cause the issue you describe.

Started a new post because I couldn’t find the answer in the archives. I’m running Dimension 4 on a Dell i7, Win10 Pro. I’ve started to use Time.is to check my clock accuracy after each sync. What I’m