Flrig and wsjtx cannot both connect to the radio at the same time. They cannot share the ports. Flrig has control, as soon as wsjtx tries to access the radio (CAT) port. crash!. The bottom line is you

#wsjt-x-crashing

I have the FT-991 and have no trouble at all. The Mic/Rear is a radio setting not WSJTX and the mode, should be set as USB not Data. Either VOX or CAT will key the radio.

#AudioIssues #Yaesu

A technique I use is to set, and hold my TX frequency on a clear spot, not on the sender's frequency where there is the pileup, There is no need to call on the same frequency as the caller. You have a

I am running Linux Mint connected directly a FT-991 radio. Up through version 2.2.20 rc3 work flawless. If I install the release version 2.2.0, it flat does not work. It will not communicate with the

I used to have an 817 bit the screen was too small for me to read so I sold it. I had it working. A few basic things coke to mind, the most obvious is the baud rate. I believe, but my memory may be fa

I have been unable to install the newer versions of wsjtx on my Linux 18.3 system. It says I must have libc6 version >= to.... I have installed every libc6 module I can find but nothing changes. I use

The problem is most likely that transmit audio is not getting to the radio. Either the level is too low, or more likely the wrong audio path is selected. I do not know about your equipment but on mine

The problem is most likely that transmit audio is not getting to the radio. Either the level is too low, or more likely the wrong audio path is selected. I do not know about your equipment but on mine

I have had some similar problems and it turned out to be RF getting into USB cables. Transmitting lower power helped but I got some clip-on RF beads and put them on the USB cables and it took care of

#AudioIssues

I have found the answer. My FT-100D has not been used much for a long time and I have had to refer to the manual to relearn how to use the features. I discovered it was in the split-mode, and the "B"

#WSJTX_config

I have wsjtx V1.8 installed on my Linux machine which is running Linux Mint version 18.2. With everything configured and connected to my FT-100D radio which is using a SignaLink interface, everything

#WSJTX_config

1- I have noticed the same thing. I think if you click soon enough, it can be a valid transmission however I suspect it will come on not matter what, if you are in the correct 15 segment of the minute

#NewUser #FT8

Your information solved all of my Windows/WSJTX KV decode problems (thank you). I have installed wsjtx on my linux system now and have essentially the same problem where everything seems to work but I

I have been using wjstx since it came out, with no problems. My computer HD died and had to be replaced. I lost all programs (only data backs up). I downloaded and installed the latest version of wjst