Hi Bill, The problem is solved. Remember I said it was probably something really stupid? Well, it was. The mode was set to JT9 instead of FT8. Made the change. Now everything works. Thanks Wayne, N4HC

#AudioIssues #Yaesu #signalink #Windows10

Hi Bill, I just checked. Yes, WSJT-X is allowed access under the privacy settings. Wayne, N4HCR

#Yaesu #signalink #Windows10 #AudioIssues

Tnx Mike! That fixed it. 73 Tom KD6TR

#Cat_RigControl #signalink

Folks, Attached is a .pdf file with 4 sources for FT-891 settings. Thank you for your input. At this point, I still have not been able to make WSJT-X run on the Pi.....so I am concluding this posting.

#signalink #raspberryPi

And we are refering to vox set in wsjt. Not Vox on radio

#Icom #signalink

Bob We can hear transmit audio on the signalink - it is just that nothing is getting through to the TS-570D. In WSJT-X settings, selecting the TS-570D just gives a communication error message from Ham

#txaudio #AudioIssues #signalink

Thanks Roger, I had previously tried both.Lowered RF Power to minimum on the 5000 which is 5 watts. Also had tried the dummy load. Just tried both again, no luck.

#signalink

>> Below are the usage recommendations copied from the Palomar Engineer >Palomar Engineering is hardly an authority on this. They are a MERCHANT. Hi Jim, What if that table is just compiled from manuf

#FT8 #signalink #txaudio

Palomar Engineering is hardly an authority on this. They are a MERCHANT. 73, Jim K9YC

#signalink #txaudio #FT8

Hi Christian, You described very well a typical RFI situation. As you don’t have any problems at 20 m using no PC. then most probable ingress point is connection cables between PC and Signalink or Sig

#FT8 #signalink #txaudio

Sarah It’s been a while since I’ve setup my SignaLink but it is likely a calibration issue. There are instructions as to how to set up your sound settings on the Tigertronic’s webpage but just off the

#AudioIssues #signalink #transmit

Thanks for the replies! I have set my radio to 'None', so I am able to run manually. Will look at some CAT solutions for sure. I ran into another issue but will make that a separate thread. Thanks aga

#signalink #raspberryPi

Hey guys, looks like I got a busy day ahead of me. As I have said, I have always used the audio cable from the Signalink to the K2. I have done this since 2015 and have made thousands of QSOs on it. O

#AudioIssues #FT8 #signalink

I have gotten it working on receive. It will also transmit. what I did was reverted my pc to an earlier date which reverted back before the last windows update. I have auto-updates turned off. I then

#AudioIssues #WSJTX_config #signalink