Hi Dave I expect that the warning is there to advise folks with a normal ssb filter that the JT4G signal is in danger of being affected by the upper rolloff of the filter, which would attenuate the up

#JT4

Hi Tom I've successfully used JT4G with 2.4 -rc1 without seeing this error. Which mode were you using prior to switching to JT4? The only subprocess error I have come across is when returning to Q65 f

#JT4

correction for 'f' read 'g'. There is also no 'g' in Q65, although it is selectable in -rc1.

#IssueReport

Hi David I think that's happening because you were on a submode letter (f) when in JT4 and when going to Q65 that would have persisted as the selected submode. There is currently no f submode coded in

#IssueReport

Hi Ernst Are you in FT8 mode? If so, the frequency table by default only has FT8 frequencies up to and including 144MHz. In other modes, eg JT65, JT4, QRA64 you should have frequencies available above

#WSJTX_config

Hi Paul PTT can be done from WSJT-X to SDR Console via CAT. You will need a virtual serial cable as well as the VAC to connect the CAT between them. Use the TS2000 as the radio in WSJT-X and as I reca

Steve No chance that your rig is switching itself to LSB on some bands and USB on others? We had someone running LSB on 10GHz and it took a while to figure it out! 73 Charlie G3WDG

Hi Andy Yes, this will work for the beacon, but not for QSOs where both periods are used. I looked at my pc clock drift and making the assumption that this is at a constant rate, set my Dimension 4 to

Hi Lance What arrangements do you have for PTT? There is a known issue with audio when PTT via RS232 (DTR/RTS) if PTT is on a different COM port to that used for CAT (or if you run in a 'no radio' sit

Hi Bob You are not alone! I saw the same error message on my 32 bit Vista machine. It was due for retirement anyway.... 73 Charlie G3WDG