A couple of suggestions, Uncheck “Flatten.” You don’t need it with a Flex. Ensure your DIGU bandwidth is set to 3000 Hz or better. Open up the Wide Graph to 3000 also (Bins/Pixel) / WSJT-X won’t decod

#AudioIssues

Just change the extension to adif. The files are the same. George J Molnar, KF2T Arlington, Virginia, USA

Make sure your PC sound card is the system default, NOT the Signalink. Also ensure only your digital mode software is set to use the Signalink. Other apps may be set incorrectly. Run a PTT line and av

The current release version works perfectly under Catalina. George J Molnar, KF2T Arlington, Virginia, USA

Are you decoding? If so, is your DT value less than 1.0? If not, your time sync requires improvement. Can you reliably make contacts in other modes? If not, your antenna may be insufficient. Check PSK

The readme document provided with the dmg gives step-by-step instructions to fix this. George J Molnar, KF2T Arlington, Virginia

VSP Manager is free for amateur radio operator use. George J Molnar, KF2T Arlington, Virginia, USA

Perhaps “fake it” is disabled? Using tones near, or outside your rig’s transmit passband can cause this problem. George J Molnar, KF2T Arlington, Virginia

Have you selected an automatic mode or microphone in the Radio tab? Set them off and try again. George J Molnar, KF2T Arlington, Virginia

First thing that comes to mind is the “flatten” function. Does the result change with it on vs off? Be very wary of using the WSJT/x waterfall for any definitive measurements or reflections of reality

Most likely RF ingress on your rig control cable. George J Molnar, KF2T Arlington, Virginia, USA

#FT8

It’s an End Of Life product, with limited and declining security updates. Also, as time goes by, applications will inevitably drop compatibility as new libraries and functions replace older ones. It w

KB2GCG is correct about Windows 7. https://www.forbes.com/sites/daveywinder/2020/01/14/windows-7-crazy-high-security-risk-as-crypto-exploit-found-in-audio-files/#3904db374bfe https://www.cvedetails.co

False decode. The “a2” is a tip, along with the large time error. George J Molnar Arlington, Virginia

If your time and audio quality are good, there are a couple of other things to check. 1) Is your rig stable? Drift will kill decodes. 2) How much power are you running? Extremely low power will not be

WSJTX audio out setting is for transmit. It won’t affect your monitoring. Check to see if your VAC channel is set to “monitor this source” in its Windows properties. George J Molnar, KF2T Arlington, V

Looking at PSKReporter, it looks like you’re getting out fine. Not setting the world on fire, but well enough. 20 is the most crowded band, with more chances for a weaker signal to get clobbered or ov

Can you share a screen shot? (Okay to send to my direct email) What does the left hand “thermometer” audio meter look like when you’re receiving? Do you have a lengthy delay between TX and RX? If you’

TX/RX turnaround time should be as short as you can make it. You want your receiver to be connected back to the antenna and fully recovered (frequency setting, muting, squelch, AGC, etc.) before the R

Sorry for the pause in answering. After looking at all the messages, I’d recommend three things. 1) Get a dedicated USB sound card device to devote to digital modes. Both transmit and receive will be