Hi, Re: wsjt-x build v2.2.2 for RPi3 Stretch In addition to the subprocessor fault when hopping, has anybody noticed that wspr hangs on a single band after a shortish while? The waterfall stalls and n

Hi Bill, Just remembered I had already disabled on board sound for the Pi3, so the usb card was the only one present. Greg

Jeff Just seen that article to disable on board soundcard for Pi 2. Actually I have already done a similar thing for my Pi 3, but procedure is different. I need to add "dtparam=audio=off" to file /boo

Hi Bill. Yes, previously there was the vnc icon above the slider which could be adjusted from 0 to 100% so I guess the audio was being sent there. Now the vnc icon is still there but the slider is gre

Thanks Jeff... will have a look. Greg g4cui

Jeff Could you give me the steps to disble the Internal audio using command line and make USB card default? Please also read replies to Bill...just got tx audio working but don't quite know how....? T

Hi Bill, I have pavucontrol installed, and ran it a day or so back to no avail. The output devices tab gives me a volume slider (at 100%) and a drop down menu for harware and virtual devices (all sele

Hi Bill, Yes, checked the slider (it's caught me once or twice in the past though). Must be something to do with sound card config on the Pi3.... I'll keep at it. Greg

Hi Bill, The RPi desktop has several utilities for checking on the audio device settings. It gives "USB audio device (Alsa Mixer) (Default)" as the sound card, so it is recognising the USB sound card

Hi Bill, Thanks for the reply. Yes, I installed that when building v2.1.2 which worked fine. Nothing else on Pi3 has changed, except for building 2.2.2 tarball. Don't know why the 'mic' works ok (I ca

Hi, Have been running v2.1.2 on a Pi3 Stretch with usb soundcard with no problems. However with v2.2.2 which I built from tarball, I have no tx audio using same usb soundcard and settings as for v2.1.

Hi Joe, I have an FT897 and got the hamlib error when I updated to 2.2.2 from 2.1.2. Selecting FT857 worked for me also. Greg g4cui

Hi, Just read Bill's reply on another thread on same issue. Yes specifying FT857 instead of my actual radio (FT897) did the trick. Now only probelm I have with this build is no tx audio. Sound card ap

Hi Built and used WSJT-X v2.1.2 on Pi3 Stretch with no problems. Built v2.2.2 from tarball and now get hamlib error 'Target VFO unaccessible while getting current frequency' and no PTT control either.

Hi Robin, I don't get that option on the list. However I have two instances running now each from a separate usb card decoding FT8 on 40 and 2m, so I think I've selected the correct options. In the ma

Hi again Bill, Been educating myself and realise that ALSA is kernel low level sound mixer and can either work on its own or be used with PA which sits on top of ALSA, so not a good idea to remove ALS

Hi Bill, A couple of issues: 1)I tried running two instances of wsjtx from same sound card mono input. I would expect identical decodes but was getting differences in signal strength and one or two st

Hi Bruce, Using pavucontrol panel, I get no applications are recording, so I don't think my instances of wsjtx are using pulseaudio drivers. Greg

Hi Bill, I don't know. They seem to work (for a while anyway.) I have checked /proc/asound/modules for the addresses of the two cards plus lsusb. But thinking about it asound belongs to alsa doesn't i

...could this mean that wsjtx instances are not using pulseaudio?