Which version of raspberry pi os? cat /etc/os-release Or you can try lsb-release -a Paste the output. Also before installing the dependency package make sure you run apt update to refresh the

Hello Dick, I made sure WSJT-X was uninstalled completely. I tried to download and install the dependencies, and it gave me the following output. pi@raspberrypi:~ $ sudo apt install libgfortran5

If you are seeing good signals on the screen but can't decode them, check your operating mode one more time. Some rigs will defaull to LSB for frequencies below 9 MHz. However WSPR is ALWAYS sent

Hi Dave, Thanks for your report. I'll try to respond to each of your many questions. 1. Your inferences about when Q65 decoding should start are not correct. Consider, for example, the 30-second

>I was focusing on the "....worked before status" piece and didn't make the connection. You are not alone. I had to test first to be sure, hi! 73, Reino OH3mA

Do you have WSJT-X rig setings like these? Also make sure you are using USB-D mode. 'Kari On 5.2.2021 20.44, Chris Mitchell via

I was focusing on the "....worked before status" piece and didn't make the connection. My display is 'back to normal'. Thanks, -Steve, W7WM

Hi Steve, User Guide section 4.1. General tab, tick ”Show DXCC, grid….” 73, Reino OH3mA

Hi Kari Yes, it does. Chris

I have apparently clicked a box somewhere and the Band Activity pane no longer shows the DX country or prefix. Will someone please tell me how to get it back? I believe I have looked at all of the

On 04/02/2021 09:41, Dave Crook wrote: Hi Dave, and Mike, thanks for the issue reports, we are looking into it and it will be fixed for the next release. 73 Bill

Chris, Does web page https://time.is/ report your time as being "exact!" ?? 73's de Kari, oh2gqc

to the team congratulations on the new Q65 mode which I find of real interest for my small station EME activities To Joe and Bill. I tested the new Q65 mode to gain some experience with the sample

Hi, I have just started using WSJT-X. I am unable to see any decodes of FT8 signals. There are plenty on the waterfall and the signals are audible through my rig speaker (IC-705). In the settings/

Thank you to the WSJT-X team for incorporating a "no shaping" option into v2.3.0. It will be greatly appreciated by many FST4 and FST4W users. Reading the release notes, the comment is: FST4/W:

Minor correction (so there is no confusion): pi@myraspberrypi$ sudo dpkg -i install <whatever you want to install> should be: pi@myraspberrypi$ sudo dpkg -i <whatever .deb you want to install>

There is an easier way: pi@myraspberrypi$ sudo dpkg -i install <whatever you want to install> blah blah blah failed because of dependencies... pi@myraspberrypi$ sudo apt-get -f install [messages

Hi, You are missing a load of dependencies needed to install the later versions. The dependencies must be installed first. Try, from the Pi@raspberrypi $ prompt ( not the download prompt

Hello friends After setting up 2.4.0-rc1 - which went fine - I first time used the [Configurations] Tab, where one may save an actual setup. This has its "special" philosophy", but one understood, you

Thanks Reino "single decode" was ticked. cheers Wayne VK4WTN