GA Karl, I had a similar problem. IIRC, I went into Raspbian "Preferences" from Main Menu and set "LOCALE" to USA. Then it worked for me. I presume there is a LOCALE for Austria. Take a look...this

Hi Andy, Realize that the SNR value is merely a measurement of the strength of the signal relative to the calculated noise floor at your location. If you reduce the noise floor at your location your

I'm wondering if paying attention to the sent SNR and the received SNR has any corresponding value when evaluating the efficiency of one's antenna? Example: I put up a new antenna for 80M recently

Hi everyone, I have Raspberry Pi4b, raspios buster of 2020-05-27 I did the installation (discribed in 3.2. Linux User guide): sudo dpkg -i wsjtx_2.3.0_armhf.deb an when starting the

YES - but it's ANY end fed wire NO,, NO, NO! The earth is a big resistor -- connecting to it burns transmitter power, reducing the strength of the transmitted signal. Indeed, the function of radials

A bit more information https://owenduffy.net/software/ATB/PL2303.htm the last paragraph. 73, Reino OH3mA

Hi Brian and All, Those problems are difficult to study without having access to at least all.txt file. It contains all received and sent messages, but it does not tell what operator actually did and

I needed to import an adif file into N1MM+ but found that N1MM+ is very picky and didn’t like the file format, so wouldn’t import it. A search on here and the Web didn’t help much, other than by

Hi Jim, as far as I know that is not quite the fully story. I believe Prolific submitted a new driver to WHQL which became the driver automatically installed and updated by

It's not the Prolific chips themselves, it is that the market has been flooded with counterfeit chips that do not work very well. 73 -Jim NU0C "John Hill" <john.e.hill@...> wrote:

Hi Geza, That's three of us who experienced the same problems. You, me and Steve VA7KH. I am not convinced it's bad handling (finger trouble), and disappointed there have been no other comments from

Hi Bill I realized that I had incorrectly renamed the ADI file. Thank you for all your input. TNX Tom N2UFM

Hi Thomas, shortly after WSJT-X starts up a message is displayed in the status bar at the bottom of the main window. That says how many worked before records have been read

I have successfully inserted my new ADI file in the Log Directory. I hav followed the instructions in the logging section of the user guide with no success. All stations show up in the Band Activity

Hi Brian, yes, but I thought, I clicked something wrong. If a QSO is ends, the message selection jumps automatically to "CQ". If the Tx becomes enabled, it starts calling CQ. I am not sure if it was a

Thank you Gary

Hi John, as stated in the ReadMe.txt file instructions, you need to reboot after copying the provided sysctl.conf file to the /etc dirctory. 73 Bill G4WJS.

Open a second finder window. Gary - AG0N

Hi Bill I am doing it from the log manager/ explorer/ finder but I need to open the Drive where the new file is. Only folders appear so I have to double click and when I do the Log Directory is

This about the shared memory error after upgrading to Big Sur. I tried to follow directions from this group but no luck. shmmax is 4194384 How to correct? I have no idea what any of this means,