did you email ve3nea <ve3nea@...> ( the author) source code etc at bottom as well maybe some help to you http://www.dxatlas.com/omnirig/ Dave Garber VE3WEJ / VE3IE wrote:

Thank, Dave, I know. The problem is that in the page there are not any document with the interface description. There are instruction to define the rig you want to use (for new/custom rigs) but

Alan, I agree with you. The only way to prove (or disprove) Mr Godfrey's work is for there to be independent peer review with newly-gathered data correlated with other position data (ADS-B?). Even

And frequency Alan? 10Hz on VHF is often seen but on 20m shift would be much less. The "clues" of Mr Godfrey are 1Hz "Drift" at the expected time. Has anyone any data about aircraft Doppler on 20m? It

WSJT-X v2.5.4 Just found that the LOG QSO Screen had an incorrect timestamp for the start of QSO for a SV1... station START = 2/24/2022 12:08:15 and END = 2/25/2022 00:54:15 The RX

Amplitude variation by an aircraft crossing the raypath of a WSPR signal is not detectable as the waves diffract around the aircraft, there is no significant amplitude loss much less than the 1dB SNR

I have been having an issue for months where my WSJT-X will function properly for a while in both RX and TX, but then fail. After some time (even less than an hour of idle time) it will remain

i did that and the error disappeared. Will the program now update this file\??

If you have the 32-bit version of WSJTX you need this:https://slproweb.com/download/Win32OpenSSL_Light-1_1_1L.msi For the 64-bit

Did you try going to lotw webside and find it. Download it and put in the Wsjt folder. sent via LG hand held device

I followed the 2.5.4 manual instructions carefully, but still have the problem.

I would go to the omnirig creator page, and explore there. http://www.dxatlas.com as long as you are refering to original version 1.19 and now 1.20 Dave Garber VE3WEJ / VE3IE wrote:

Remember that Elecraft rigs need 4 bars of ALC or they will start power hunting.You have to adjust power on the rig instead of WSJT-X. Mike W9MDB

There's this pinned post which might give you some

I am trying to get my K4D properly transmitting with WSJT-X; the CAT commands work and RX is working; now I need to know how to set the drive level properly. Is there a wiki somewhere I could refer

Hi, I'm trying to set up WSJTX 2.5.4 on a Raspberry Pi 4 to connect to my FT-991A using just the USB cable. I've already tested WSJTX and the FT-991A on Windows and it works great. However I'm

On restart it's fine. I set all my USB/HDMI devices to NOT sleep and will see how that works out. Thanks! -- Bret/N4SRN

If you restart WSJT-x or deselect/reselect the audio inputs and outputs, does it start working again? If so, it's Windows seeing some device (dis)appear, usually because some USB, HDMI, or other

I have my ICOM IC-705 running @2W (20% TX) with Win10 WSJT-X 2.5.4 on Win10. After some hours of WSPR on 2m, I get "Error in Sound Output Requested audio output format is not supported on device."

It seems Window re-enumerates USB devices whenever a change is detected.So turning USB devices on/off or plugging/unplugging is not a good idea.There are lots of reports of enumeration failures on the