WSJT-X v2.5.4 Just found that the LOG QSO Screen had an incorrect timestamp for the start of QSO for a SV1... station START = 2/24/2022 12:08:15 and END = 2/25/2022 00:54:15 The RX

Amplitude variation by an aircraft crossing the raypath of a WSPR signal is not detectable as the waves diffract around the aircraft, there is no significant amplitude loss much less than the 1dB SNR

I have been having an issue for months where my WSJT-X will function properly for a while in both RX and TX, but then fail. After some time (even less than an hour of idle time) it will remain

i did that and the error disappeared. Will the program now update this file\??

If you have the 32-bit version of WSJTX you need this:https://slproweb.com/download/Win32OpenSSL_Light-1_1_1L.msi For the 64-bit

Did you try going to lotw webside and find it. Download it and put in the Wsjt folder. sent via LG hand held device

I followed the 2.5.4 manual instructions carefully, but still have the problem.

I would go to the omnirig creator page, and explore there. http://www.dxatlas.com as long as you are refering to original version 1.19 and now 1.20 Dave Garber VE3WEJ / VE3IE wrote:

Remember that Elecraft rigs need 4 bars of ALC or they will start power hunting.You have to adjust power on the rig instead of WSJT-X. Mike W9MDB

There's this pinned post which might give you some

I am trying to get my K4D properly transmitting with WSJT-X; the CAT commands work and RX is working; now I need to know how to set the drive level properly. Is there a wiki somewhere I could refer

Hi, I'm trying to set up WSJTX 2.5.4 on a Raspberry Pi 4 to connect to my FT-991A using just the USB cable. I've already tested WSJTX and the FT-991A on Windows and it works great. However I'm

On restart it's fine. I set all my USB/HDMI devices to NOT sleep and will see how that works out. Thanks! -- Bret/N4SRN

If you restart WSJT-x or deselect/reselect the audio inputs and outputs, does it start working again? If so, it's Windows seeing some device (dis)appear, usually because some USB, HDMI, or other

I have my ICOM IC-705 running @2W (20% TX) with Win10 WSJT-X 2.5.4 on Win10. After some hours of WSPR on 2m, I get "Error in Sound Output Requested audio output format is not supported on device."

It seems Window re-enumerates USB devices whenever a change is detected.So turning USB devices on/off or plugging/unplugging is not a good idea.There are lots of reports of enumeration failures on the

Thanks, I hadn't explored further than the readme. Terry

I should have added that I have gone through the usb power settings and set them not to sleep. If I power the radio straight after a pc reboot, all works fine, but I have seen the problem occur

Try https://helpdeskgeek.com/how-to/prevent-windows-from-powering-off-usb-device/ --73, Glenn, AF8C -- This email has been checked for viruses by Avast antivirus

This is possibly easier and quicker https://www.uwe-sieber.de/english.html Com arbitrator tool