Mike, Yes, WSJT-X now connects to the rig immediately. I re-checked split using "rig" and "fake it", and they work fine also. However, there were still some warnings in the wsjtx_syslog.log not

I tried a different cable so that is not my problem. wrote:

Hi..here is the list from my 857D that works for me with an M-Link interface (which has since died)... :0) FT 857 Settings for FT8 Digital General Tool Bar Mode FT8 Decode Deep Display x Blank

Unfortunately that didn’t help my problem, but I appreciate your efforts. I think i need to review my software settings or menu settings in the FT- 857, with someone who has the same radio. If you

Please try this DLL -- this is the 64-bit version.  Looks like I had a typo... https://www.dropbox.com/s/7aejdv74nfjxr0q/libhamlib-4.dll?dl=0 If it still takes too long... Please place this file

Today I left a logging dialog box open because the grid square was empty. I believe there is no way to edit a QSO record after it has been accepted. Right? So, I was waiting for the station

In WSJT-X Settings/General, check "Start new period decodes at top". 73, Jim N6VH

Joe, I tested with both "Rig" (which is what I normally use) and "Fake It". In both cases, the rig control behaved as it should. However, with the new file, it takes about five seconds to connect to

Thank you very much John. I will check my drive settings. Mike N3HR

Following up on this topic from a couple of weeks ago. I use WSJT-X for FT-8 and FT-4 it would help a lot if the two windows would minimize and come back together. When closing the program only the

COM3 and COM4 were not on the laptop before I did the driver download. There are no other COM ports listed. I followed the instructions in the 101MP manual for settings. It feels like the radio is

It must have been in another topic somewhere that I provided another solution: Open the Task Manager (Ctrl-Alt-Delete), then, on the Processes tab, locate the JT9 process and click End. I'm thinking

[A resend as my mail got stuck somewhere for two hours. May be my ISP spam filter or something similar.] SSB transceivers are used to translate an audio frequency FT8 signal to RF using Upper Side

Hi Dave, All WSJT-X modes use upper sideband on all bands, when received with an SSB rig. At RF the FT8 signal is just eight frequencies one at the time. That transmission/reception method is call

All known bugs have been fixed and Hamlib 4.5 is close to being released barring any new bugs reported.Please test the latest hamlib -- including Fake It and Rig Split. Would also like to know any

Yes.  Haven't reviewed it yet..still working another bug before releasing Hamlib 4.5

Hi Mike, Sent you a private message. did you receive it. Sam W2JDB

Hi Larry,Give me a call and we can hook up using AnyDesk https://anydesk.com/enSounds like a problem I've solved before but can get a bit complicated. 217-960-0233 Mike W9MDB

Shutdown WSJTX and remove C:\Users\[username]\AppData\Local\WSJT-X\WSJT-X.ini This will start a new config when you restart WSJTX. Mike W9MDB

Hi Mike, So, just like your rig acts like an exciter by putting out say 40 Watts in order to drive a RF Power Amplifier to 250, 500 or maybe even 1500 Watts... your computer's audio thru the USB