That’s only true for FT8 and FT4. With 30 s time-slot modes it alternates between 00 and 30. 73 Phil. Sent from Mail for Windows

Where does one get grid_from_gps.py? I've got an enhancement issue to add GPS devices so this would be an additional capability. Mike W9MDB

If you are working a QSO, I have observed that you can change the time slot of your response by manipulating the button. Check it out for yourself. If you work a response to a CQ, notice that the

WSJT-X always automagically selects the correct sequence when calling a station 73 Frank W3LPL

FWIW .... the "Tx Even/1st only applies to you calling CQ, not to responses. Neil, KN3ILZ

Rick, When the ADIF committee were asked to add FT8 as a mode – it was rushed through and the MODE FT8 was added. When asked to add FT4, there was more notice and in line with ADIF 3 policy was

This is what have observed. If you double click on a CQ, WSJTX sends the request. Notice the UTC column. The time stamp will have an odd or even number at the end. I believe this determines the

Hi Harvey, looking at the grid_to_gps.py sources, it appears to set up a UDP server on multicast IP group address 224.1.1.1 and listens on port 5007. If you set those options in the WSJT-X

Hi Jim, what happens if you restart Windows then try again? 73 Bill G4WJS.

Help; I have WSJT-X version 2.4.0 on windows.  I have a GPS hooked up via com port.  I found very limited information on the General Tab setup "AutoGrid".  The information refers to Python

I don't run Ubuntu, but I currently run WSJT-X on Fedora Core 33 and 34 with no problems.  It required no drivers and seems to be rock stable. __Reid, WB7CJO__

I started getting error messages and the now the program will not start. I have uninstalled it and delete the download and started over and still getting the same messages,

Hello Martin - Bill too. I read the Two Generals problem and now understand the philosophy embedded in the new-to-me v2.4.0 software. Now, I'll go with the 'flow' provided by the software. Surprise

Yeah, but IME Process Explorer won't show things like CPU overheating because of blocked fan vents or disk errors causing retries, and some malware can hide itself from monitoring, hence my

You don't need any special drivers for Linux.  I have an IC-7300 that I use with WSJT-X 2.5.0-rc5 on Kubuntu 20.04    I've been using my TS-590SG more than my other rigs lately

Hi Gwen, Regarding your freezing of the IC-7300 on the transmitting stage -- what have you done regarding grounding and RFI (Radio Frequency Interference) shielding of the transceiver, computer and

Michael, Thank you, found the information and learned how to search a webpage (crtl-F) -- Glen, WB4KTF Austin, TX

Hi Rick, the ADIF fields for modes used by WSJT-X are consistent with the official ADIF specification. 73 Bill G4WJS.

Again, Process Explorer shows no resource being anywhere near maxed out. FYI Process Explorer is sort of like Task Manager on steroids, shows details to the thread level, is not installed by default

I set up WSJT-x 2.4.0 on a Windows 10 computer. Everything worked fine for the 1st 48 hours. I then made a QSO attempt and the transmitter froze in the ON state. I had to manually cancel the