I find that responding to CQ's gets logged into PSKReporter, as well as CQ's. 73 de w6akb vk3ama.ham.apps@...> wrote:

What mode do you have the 7300 set to? It must be SSB-D (Thee D is for data) How many pips are you seeing on your ALC meter when you transmit? What happened when you used the TX "Test " option in

Definitive measurements of the probability of decoding an FT8 message when the transmitting station starts transmitting after the beginning of a 15 s interval were published in QEX about two years

Hello Evan, could it be that you did not connect your TS480 audio input to the soundcard line out (or speaker) you are using for digital modes? If a soundcard 4-USB Audio Device is shown under

Actually, it does have a 'B4' setting ... no color highlighting.    If a station calling CQ is not color highlighted, WSJT-X has determined that it has been contacted previously according to the

Hi All, It is about stopping "Call 1st" responding to stations that you don;t want to respond to. If you call CQ DX and the guy down the road responds, capturing the QSO and preventing you

Not sure if WSJTx has a "worked before" highlighting. If it does, I don't use it. However, it does have highlighting for "needed entities". By properly setting up the "needed entries" color

Two items, I don't want a "filter out" for any station I decode regardless of band, grid, country, or callsign etc. However I would like a 'color' specific to that station I have worked before and it

You didn't indicate what mode you have the 991a set for. I believe you should be using DATA-USB, not USB when your using the rear connector. Check that.

You haven't mentioned what time synchronisation software you are using. This is the usual cause of signals not decoding 73 Charlie G4EST www.g4est.me.uk Stay safe out there

Are you sure your radio is operating in USB (upper sideband) or USB-D(ata) mode and not LSB? When you say you can Tx correctly, does PSK Reporter show that your outgoing signal is being decoded by

This is ham spirit. Pietro I2OIM

Hi, Whilst it is nice to be able to filter your incoming traffic, spare a thought for those who are in "unwanted" grids/dxcc/whatever. Remember you all started out as newcomers to the bands and if

One reader of this group sent me an email about FT8 being USB on all bands. I tried USB on 40 meters and decoding started working again. I thought my configuration was broken but as it turns out, my

FYI, If you're looking at PSKReporter only CQ decodes are uploaded, so if you're testing using free-format messages they wont get spotted. de Laurie VK3AMA

Hi Tim Many nice questions. I try to give some generic information. WSJT-X uses a powerful forward error correction and synchronization patterns and in a S/N situation decoding probability is high

Yes, I have my time set using Meinberg. But that was a good suggestion.

For the 991A menu 106 needs to be REAR For the IC-7300 make sure you use Data/Pkt mode and the recently added FT8 mode on the rig. Mike W9MDB

And follow the link to: https://www.rsgbcc.org/hf/rules/2022/r80m_ft4.shtml Note nonstandard frequency (at least on 40M) and 90-minute contest time window. Unfortunately, that’s mid afternoon in

Is your time correct? Check http://time.is Mike W9MDB