Listening down here in kent Peter M0PWX M0PWX Grabber Page (qsl.net) MSK144 Beacon for the Leonids later this evening. Latest operational state can be found here.

Sounds like the classic issue of RFI. Most likely caused by Common Mode Current. In most cases, grounding or earthing won't correct the issue. On the other hand, bonding all chassis together is

I find that if you are on his frequency or overlapping his, it will disable your TX. this was built in, i believe to prevent qrm. does it do it if you hold frequency, then tx elsewhere? Dave

Thanks Allan! Glad it's not just me! Laurie already posted that it's not a JTAlert problem. Wish someone from the WSJT programming crowd actually looked at this group! -- John P. WA2FZW

After a long period of inactivity went to use software and interface will now decode the warbles and won't key the transmitter (ICOM 756 Pro3) Have spent the afternoon trying to get this thing to work

MSK144 Beacon for the Leonids later this evening. Latest operational state can be found here. http://g4jnt.com/MSK144_Beacon.txt Andy www.g4jnt.com

Any changes will be shown here http://g4jnt.com/MSK144_Beacon.txt Andy G4JNT

I plan to run my MSK144 beacon over the duration of the peakof the Leonids Frequency 50.3755 (SSB Carrier, or ‘Dial Frequency’). Centre of the RF is at 50.377MHz Duty cycle 100%, sending a

Messages sent as a new topic don't seem to be appearing, so I'll try replying to an existing thread. Will be running tonight from 2100z More info at http://g4jnt.com/MSK144_Beacon.txt Andy G4JNT

Double check your path to the log file. Look at the path in Log4OM and ensure that's the path in JTAlert too. Mike W9MDB

wrote: Its not a JTAlert issue. I am seeing the same thing. It does not do this all the time but it is frustrating. Using 2.5.1. I push the TX Enable and it fires off OK. Unless I get another RR73

and mine did log, without a log file in the correct box, but it could not confirm.. Dave Garber VE3WEJ / VE3IE

Hi, I have the IC-705, It will almost certainly be RFI. I was lucky, I had a well screen cable from other experiences with RFI I used a screened double ferrite cable from a Digital Camera. On

How are you connected to the radio? -- Don W6CZ/W6ZB DM07bk

Thank you Mike, the new DLL works fine. I could download it without problems (no warnings using Firefox). 73, Lui, DL6FBR

Hi Mike, the nee DLL works fine. I had no problems downloading with Firefox. 73, Lui, DL6FBR (It seems my first reply didn't come through.)

For a moment. After one transmission, I lose audio input to WSJT-X - I know there is a signal coming out of the radio's headset jack, but nothing is showing up on the signal bar (on the left of the

Hi AH0U, just installed WSJT-X on a Raspberry-2W (small PI wit 512MB + WIFI, no audio jack). I start from a fresh "2021-05-07-raspios-buster-armhf" on SD, I enabled some stuffs like SSH, VNC and

Hi everyone, I've installed WSJT-X (v2.3.0) on my Raspberry Pi 4 running Bullseye. My radio is an Elecraft KX3, and rig control is working fine with the USB cable. I have a cheap USB sound card in the

I have spent several days trying to get my Pi4 to work with a Signalink and WSJT... I can receive and I get the Red light on TX but I cant seem to get audio out to the TS450... anybody done this and