Signalink is a USB soundcard - it has not CAT capability. You will need a separate USB to CI-V cable or USB to serial cable with the Icom CT-17 CI-V converter for CAT. That said, the IC-706 does not

Sheldon, The K4 provides 2 com ports on the USB interface which will register as COM ports in windows. The audio interface that the K4 provides on the USB interface should appear as an audio device

Sounds like the RX filters are narrowed down. After doing CW with narrow filters I have to always set the filters to wide open again if I want to get on FT8, otherwise all sorts of wierd things are

Yup . . . need a serial cable (typically) for CAT along with the Signalink. (I run my FT1000MP-MKV and FT847 Yaesus that way flawlessly . . . ) WSJTX on the '1000, and SatTrack on the '847 (as far as

Hello OM I’m guessing it doesn’t change frequency when you select a different band in WSJT-X? SignaLink doesn’t provide CAT control, only audio, hence no PTT. 73 —mco AB1TZ

Submitted 9k image . . . apparently it is stuck awaiting approval somewhere . . . -- Sent from my Android device with K-9 Mail. Please excuse my brevity.

Image of this condition attached - all 9KB of it! :-) -- ================================================================================ Tim Dawson (tadawson@...)

I have IC706 original connected via SignaLink and programming cable and can receive just fine on 20M/FT8. I can use mic in FM to transit 100w/swr 1.2. However in wsjtx ptt doesn’t work and I

I would not think that an audio device would appear as a COM port - COM ports, by definition, are either serial,ports, or USB implementations thereof . . . not audio . . . -- Sent from my Android

The Windows 10 Device Manager is showing the Audio Codec on com4 and that is what I have selected on the WSJT-X set up. Clicking on the Audio Codec tab indicates a status of working. However, I will

No need to apologize. I appreciate all of the suggestions. I checked the USB settings and I know that the digital part is working because WSJT-X has no problems in following changes in the rig VFO

Yeah, my capture is just the popup, so it should be small. I made the prior post via the web page and not email, and did not see an attachment button . . . since the thread is running, I'll add it

The site does allow images when it is not possible to copy and paste the text. This seems to be one of those occasions to me. Please make sure that only the essential part of the screen shot is in

Ok, I thought I replied to the tread. I don't know what happened, but, it's working again! I double-checked the settings in WSJT-X and the 7300 and made some minor adjustments to the levels in the

Alright, it's working again! So, I went through the settings on WSJT-X and the 7300 again and made some minor adjustments on the levels as some suggested. I went as far as unplugging my USB connection

I am getting the popup that results from "Solve for calibration parameters" as largely mangled text. THe header "Good Calibration Solution" is clean, but what appear to be the two lines immediately

I'm sorry if I sound a lot obsessive bug I am. I have encountered very similar problems several times and eventually nuked the whole thing and reinstalled windows 10 and all the ham software. I've

wrote:

There might be a squelch in the USB connection that is shutting down the connection. Icom has that (unless I'm misunderstanding what it is) so try to find it and set it so that nothing gets

If y haven't already done so you also might try different USB cable.