Hi Tom, Could it be so simple that Windows has changed security settings and don't allow microphone? I am assuming that you are using Windows 10 or 11. It is in security settings something like Allow

Using Net Time, which seems to be operating normally. Appreciate your getting back to me. Tom N3TCG

Hi folks, since fenths i change my old converter for audiosignals to an ETM-Digi1 with optocoupler, transformer, stored in an tin box. So it seems to be immune against radiation of cabling, trx and so

Hi Richard, Gee, that's old! Please upgrade to 2.5.4! Are you sure that your rig is actually /dev/ttyUSB0 ? With rig connected pen terminal and do: ls -l /dev/serial/by-id/ This will show you the

Let's try again without the HTML formatting messing it up. Please place this file as described

Windows 10 build 19044, patched and up to date X64 AMD 8 core processor, 3.5 years old, 16 GB of RAM Sometimes the behavior happens 2 or 3 times a day, other times I can go a week with no

Please place this file as described belowhttps://www.dropbox.com/s/t52ngcalsgnpm8m/wsjtx_log_config.ini?dl=0 C:\Users\[username]\AppData\Local\WSJT-X The WSJT-X_Rigcontrol.log file will be in the

That is a really old version of WSJTX. You should upgrade and try again.  We can go from there.  2.1.2 won't even support debugging the

STUDYING the documentation for WSJT-X on the website is a great start. 73, Jim K9YC

I use 'what'...200 to 3000Hz.

If you have an older rig with an AM filter and IF Shift/Passband Tuning you can use the AM filter to extend your RX top end. If not using CAT control you do still need to watch your TX frequency to

What software are you using for time syncronization? If your computer time is off by more than a second, no decodes can be a symptom. Ron - KJ5XX

One other possibility is that somehow you changed the bins/pixel setting in the Waterfall controls. Whatever it is currently set to, increase it. The signal displays will get narrower. Also, the

Usually, 0-3000 is sufficient. I think Joe says the ultimate bandwidth is up to 2700, but read it for yourself the manual. I personally work the edges pretty regularly, up to and including 3000. Be

Mostly depends on your rig. If you have an old SSB rig that only does 2500 Hz, then set it to 2500 Hz. If you have a modern rig that’ll do 4000 Hz, then set it to 4000 Hz. Open it as wide as it

Hi Al, Could that AGC be in Windows sound system including control of the sound card? I don't see any reason or capability for WSJT-X to do any AGC kind action on audio. Actually it sends audio at 0

My old laptop is starting to stumble after a decade of solid service, so I bought a new one and darned if I can get it properly configured. Laptop - Acer Nitro 5 running Ubuntu 20.04 Rig -

I have same problem, I just use FRig for CAt control, select it a radio in WSJTX Dan KC2STA -- Dan Ziolkowski KC2STA SKCC #4290T Ubuntu LINUX

I am new to this program and learning on the fly. At present, I discovered I could increase or decrease the range of the waterfall. Of course, in doing so I opened up a lot of contacts I was totally

Hi, nope. no Difference. ( with WSJT-X 2.6.0-rc4) Rig still reacts the same way. still not working Am 09.10.2022 um 08:42 schrieb Alex Kindred N7AWK: