I operate QRP with my FT-818 and dipole. I have to use every advantage to make challenging contacts. Bob. W7DIT

David, The place a narrow IF filter *DOES* help is when trying to copy a weak station with a very strong (local) station > 1 KHz away. The narrow filter can keep the strong station from reducing

Thanks Reino, that's exactly the myth that is starting to circulate... Dave (G0DJA)

Thanks Charlie, I'd quickly read through the User Guide and must have skipped over that section. i'll go back and cut and paste to a txt file. Dave (G0DJA)

Hi, Ed:  Please cut and paste the console text so that we can see from what directory your were in when you typed the command and the exact response from the

Gary, Thanks for the link! The instructions seem straightforward, so I will give this a try if I do not hear of any other solution other than building from source. Ed, K0KC

Ed although I haven’t yet tried RC3, I had the same experience with RCs 1 and 2 on my RPi 400. I ended up compiling from source. I used this to do

I recently decided to update my Raspberry Pi 3B+ to run under the 64-bit version of Raspbian (Debian-based) and now wish to install WSJT-X 2.6-rc3. I downloaded wsjtx_2.6.6-rc3_arm64.deb from the WSJT

From: David Tanks <ad4tj@...>To: WSJT-x Group <main@wsjtx.groups.io>Sent: Saturday, August 27, 2022 at 07:57:48 AM EDTSubject: N1MM and WSJTX: How Do I Update WSJTX that is used within N1MM?  

In my mind (until your receiver is not saturated by near sources) the larger filter is better. Filtering in digital as the SW does is more efficient and phase neutral. Pietro I2OIM Pietro (via

Hi Joe Many Thanks, I’ve kept the file, whom do I direct it to, and email address ! Regards Ken.. G0ORH Like it’s owner, this email is covid free!

We did some work to get both regular and fake it split mode working on the FTDX5000. Please try the lastest Hamlib DLL too that will be dated 220827 that will be available later

After all the years working FT8 and FT4 I STILL can't understand how so many stations answer with NO GRID SQUARE programed into their configuration!

Thank you, one and all, After setting the 706 correctly and going through the w10 computer set up, I have it all working. Made 5 contacts in the process.😊 Now, is it optimum? Tweaking over

Gary, Unplugging the microphone will take care of the problem. Turning down the microphone gain would also work. 73, Kent AA6P

How can you possibly imply that most other operators do to?? I do NOT. No reason too. I just make contacts and don’t worry about all these myths. NA8W Sent: Thursday, August 25, 2022 13:15 To:

This has been recently discussed in another thread. This message is a good place to start reading the thread. https://wsjtx.groups.io/g/main/message/37564 73 -Jim NU0C "David Ackrill"

I always have Hold TX Freq checked, but there have been a few occasions when I've called stations that were mondo-loud who didn't hear me that I really, really wanted to work (needed 6M grids, DX

You want to adjust your waterfall to have just a little bit of "snow" across the waterfall -- speckles sprinkled throughout so you can see just a little bit of the noise floor. They you'll start

Ok Mike I'll give it another try with rc3. Keep in mind my failures occur when in the Split:Rig mode. It has never failed with split off. Split:fake it has never worked consistently with the