You should select "TX Hold", keep your transmit frequency in the audio bandwidth and call the station you want to contact. Don't jump about following the TX frequency of the stations you want to

The receive frequency is acting properly, and I suspect the transmit is too. I’m guessing you’re expecting the transmit to jump there too. This isn’t SSB, RTTY, AM, or FM. What you’re

Phil The S/N ratio reported  by WSJT-X is normalized to a 2.5 kHz bandwidth no matter what your IF pass band BW is set to. The actual noise BW is just a few Hz per tone (6.25 Hz for FT8, way less

If I remember Joe’s comments on this correctly, it will affect the SNR readings, because the noise level of the receiver is taken over the entire bandwidth that the software monitors. If you are

Here is a sample analysis of SNR values decoded for the same station during a 1 hour period.Only stations with 15 or more decodes were included.  Rig is TS590S, running WSJT-X 2.6.0rc3 with deep

CRASHING AND FREEZING NOW SOLVED.Might Be Of Help. Problem solved with replacing hard drive to a SSD. Memory now lower with Dell Inspiron 17. 5000 series W10 8GB Ram ,352 GB free P.C 7 years old, now

I think the myth is that a higher S/N means that the signal is more easily decoded. S/N is the ratio of the signal to the noise received across the whole receiver passband, not just the 50Hz bandwidth

Crashing on some bands but not others is an indication of RFI on that particular band. Move/change antennas, add common mode (RF chokes) to your antenna feedline(s), and add ferrites to your USB

Since installation of rc3 (downloaded from the K1JT website) it has crashed five times. No additional files have been downloaded or installed. The crashes have all occurred when WSJT-X is in FT8

I agree with Jim, K9YC. I make contacts and log them with or without grid squares all the time. Sometimes I am asked for my grid square and I give it and move along. I never really ask for the grid

Update. Since yesterday I work the 2m band with radio (new antennas...), before I didn't. rc3 crash frequently leaving orphan JT9 or JT9 + Host console processe. When I work QO-100 (tx radio on 70cm,

Well I can tell you that if they send the RR73 and I'm in the DIGI contest and there is no grid given I just press CANCEL when the LOG QSO screen comes up an go back to calling CQ.   So the ones

Exclude that directory from your antivirus program. Mike W9MDB

Are you sure you're using WSJT-X ??    There is a clone that has this issue, try downloading the original and try again. Neil, KN3ILZ

Brain cramp -- somehow I forgot that this is the weekend of the WW Digi contest. :) The reason that stations are calling without their gridsquare is that they don't know it's a contest weekend, or

Since the earliest days of ham radio awards, the requirement for a QSO are exchange of callsigns and one other piece of information, and both stations copying R from the other. It doesn't matter what

What version of WSJT-X are you using? Please post your settings as we can not guess what might be configured incorrectly without seeing your settings. BTW, the current version of JT Alert is 2.60.1

No grid square no contact most are con testers who want to hide I just hit esc and move on. Bob WA6NFJ CN85

Brian I’ll send you what I have tomorrow after the contest is over. On Joe’s suggestion yesterday, Ron WV4P and I were asked to replace the Hamlin FLL for RC3 with the version that was used for

Greetings, I'm gathering information on wsjt-x on Microsoft Windows crashes that people are experiencing and reporting in this group; I've read posts from W1UE, WV4P, W3RJW, WB5JJJ about this, and