Hi Chip: Yes, N1MM is Windows only. MacLoggerDX is a good program for Mac users and very, very well supported. Goodluck with the rest of the config! 73, Kevin

Kevin I think I am good grid tracker running logging to QRZ. My next mission is to get eQSL and LOTW going I haven't tried them yet wanted to wait for the new computer so I dint have to do things

Change the Mode in the rig settings to "None". See if that helps. Mike W9MDB

Hi (name?), K8RDG, Have you set up the 60M frequency in the WSJT frequency list? "F2 >> Frequency". This should work. Larry / W1DYJ

Hi Chip, great news! I use GridTracker, it is pretty easy to set up. GridTracker can rebroadcast UDP packets received, to your logging program for example. I use MacLoggerDX. WSJT-X sends UDP

I'm new so forgive me if this topic has been covered already. I seem to have an issue that when I'm in memory mode on my Yaesu FT-991A and launch WSJT-X, the radio auto exits memory mode into VFO A.

Kevin Good News, I figured out the com port issue, I shut the Mac down then plugged the radio into the usb and then started the radio. success I have cat control and am recieving data I need to figure

I updated to the most current CTY.DAT File. Put it in the directory where it is supposed to be. Restarted the program, and no change. Not that it's a big issue, but at least with JTDX that gives me

CTY. DAT exists in my WSJT Directory. I also have the Correct settings in the settings menu. Evidently something is not syncing. Mark KB3Z

Ray: Thanks for the response. I have replicated the issue with a TS-2000, an FT-817, an FT-100 (without using CAT since Rumlog via UDP won't support it), and no radio at all--using a Microkeyer II

I had the same problem months ago. Turned out that I had to reset the "colors" for the various categories i.e. new DX, new Continent, new country, etc. Sorry that I can't recall the specific choices,

Perhaps your are missing file "CTY.DAT" or the file is corrupted? Search the WSJT-X installation to see if CTY.DAT exists. I'm nor running on Windozie so cannot tell where exactly CTY.DAT should

>Only it does not work!! Hi Joe, Do you see anything there? Instead of country you may see e.g. CQ zone depending on your Color settings. Does colors work otherwise on CQ messages? I had no

I just check the symbol pattern generated against that output from 'code'.exe There isn't an FT4CODE.EXE in the normal distribution, but it does exist in the distribution users build for themselves (I

Kevin Thanks for the reply I have checked silicon labs website and have the extension "com.silabs.cp210x 6.0.2" and see it when I check the system report it shows it there. it is

I've been running a calibration for a new radio (I haven't had to run one for years!). The manual states "initially no measurement data is saved to the fmt.all file although it is displayed on screen;

Hi Yes! Only it does not work!! de Joe 4X1RV

Hi Chip: I don’t have an M1 Mac but use my MacBook Pro and desktop iMac all the time with my 9700/Elecraft K4 for WSJT-X. The first thing I would look at is to get the serial ports recognized when

Hi Mark In File => Settings => General check "Show DXCC, grid , and worked-before status" uncheck "Show principal prefix instead of country name" . 73's de Kari, oh2gqc

Hi Chip: I don’t have an M1 Mac but use my MacBook Pro and desktop iMac all the time with my 9700/Elecraft K4 for WSJT-X. The first thing I would look at is to get the serial ports recognized when