Can't you overdrive a 'single sinewave' to the point where it produces splatter? 73, Willie N1JBJ

Hello everyone. I have been using Mac computers for years and have recently switched over to a PC with Windows 11. I want to use FT8 and other WSJT-X modes. I have been looking for a time sync

Larry is right. Auto Seq. is the culprit. User Guide § 7.3 gives details. It is worth noting that when Auto-Seq is enabled, the program de-activates Enable Tx at the end of each QSO. The Call 1st

New DLL.  The FT-710 does not have a CAT manual yet and there were some differences from other Yaesu's This is the 64-bit DLL that should work now.We did have to use the standard port and changed the

They probably just have a higher local noise level than you do. Don't assume something that is not in evidence. Everyone does not hear everyone else on the band. Bob - wd6dod

Make sure you have a call sign entered in the box that is somewhat in the middle of the screen. Also make sure that the settings screen has your call sign and grid. 73, Sam W2JDB

Hi Neil, been using the BT CAT with 817 for a few years on and off never noticed a problem. But I’ll bear it in mind. Klaus G7RTI

All, thank you for your help and comments. This issue has been resolved. I found the answer here: https://wsjtx.groups.io/g/main/topic/no_alc_or_power_when/80143070?p= Somehow my DATA OFF MOD went

Well thanks to Mike W9MDB I now not only have a FT-710 radio to select, but the CAT control works at full speed. But more importantly than that, I now have perfectly working audio with the single usb

Thanks to everyone for lots of good input here. So many comments that could be made in reply! I, too, have found that I can shorten my TX cycle by 2 or 3 seconds on either end and still have a pretty

Hi! I somehow deleted the standard messages. Clicking Generate standard messages does not recreate them. Can anyone let me know how i get them back? Thanks!

Things that make me grumble: 1. Splatter! UGH! While I understand that we can't see our transmissions on the Waterfall (ain't physics a bear) there's enough info out there on how to properly

Hear hear! Although with good propagation much lower power can sound like a KW and look like it signals strength wise on the waterfall. Hope the KW guys are few and far between but how do you know

I would like to add a yes to waterfall watching from a QRP operator. I have two radios that I use for FT-8, an FT-818 and a QRPGuys transceiver both of which make 6 watts or less. I am frustrated to

Sorry to break it to you but FT8 is not a low power mode, never was. Strong and weak signals coexist just fine. If you are running split as you should it is not a problem. You can demonstrate this

Completed three QSO's on FT8 and it seems to be Auto Sequencing now. I'm not sure what happened, but it seems to be working again. Thanks Larry & Dennis for coming to my rescue! Gene - KD9KMF, OUT!

Afternoon Larry, You had me going there for a minute! Auto Seq Is checked marked! I've cleared the box, then check marked it again... Trying again now. Gene - KD9KMF

Gene Did somehow the "Auto Seq" box on the main screen get unchecked? Dennis W1UE

Hi Gene, Did you inadvertently turn off "Auto Seq?" Larry / W1DYJ

To the point about "... you NEVER get to hear the offset you are transmitting on unless you stop transmitting for a cycle," I don't think it is necessary to wait for a full cycle to check to see if