Hi, You may disconnect USB cable to see what changes. Or power up Signalink without Signalink USB cable connected and then connect the USB cable to see changes. Also Signalink power down will do. 73,

It depends. Sometimes i restart wsjtx. Sonmetime dax restart sometime just re selecting the audio sent by ve3wej on lg phone yahoo.com@groups.io> wrote:

Dave, How do you get the audio back ? Fritz KG7JLN

I have 12 devices under "Universal Serial Bus Controllers", can't tell which one is for the signalink, have gone through each one and updated the driver

I’m sorry. Section 3.1 Bruce McLain - K5WBM bruce.mclain@...

Did the driver install correctly for the Signallink? Can you see it in Device Manager? UE aol.com@groups.io> wrote:

Section 3.2 of the manual has the answer. Bruce McLain - K5WBM bruce.mclain@...

New computer. Just reinstalled wsjt-x but am getting an error message each time I boot the problem. The message states that the program is unable to load LoTW data because of a network error with

Disabled both -- no change

1. Wrong sound card selected  -  using Signalink USB - how would I select it? 2. Wrong sound card input selected -   set to both set to usb audio codex 3. Input to the sound card not adjusted

Not sure what you mean Windows sound setting?

get wsjtx working first, do not run HRD or jtalert. if it is not decoding, perhaps your clock time is that far off. I use bkttimesync, but there others go to time.is on the web and check you

Stan You also need to check the Windows-Settings-Sound to make sure that what you want is accurately in there. This is in addition to having wsjt configured correctly. Dennis

Stan Do any signals show in the waterfall? If not, Then either 1. Wrong sound card selected 2. Wrong sound card input selected 3. Input to the sound card not adjusted correctly. 4. If you have a USB

If they have the text messaging function enabled in WSJT-X, I ask that way.

Look in services for "WAV" audio items.  Disable them.  I believe  there are two of them. Mike

Yes, I have asked stations to move to FT4 -- *Anthony Luscre* *K8ZT* Ohio Section Section Youth Coordinator & Education Outreach ARRL - The National Association For Amateur Radio™ k8zt@...

All, My experience with moving from FT8 to FT4 is mixed. When a station transmits QSY FT4 I will usually go and often make a few QSOs. However, the "well runs dry" in a few minutes and I move back

Dennis,  That's the issue, trying to get it to work with just the rig. Followed the setup procedure  and no signal decodes? StanKK3KK

Stan My best advice- get wsjt-x to work first. If wsjt doesn’t work, then the two programs won’t work. Once that works, add in HRD. Dennis W1UE aol.com@groups.io> wrote: