I agree, it doesn't seem like very good design in this respect, Mike. I would have thought there ought to be a couple of resistors to knock the signal level at the CODEC output down 20 dB or more

wsjt wont allow without the error popping up ( in fox and hound mode) Dave Garber VE3WEJ / VE3IE wrote:

Hi Joe Thanks for getting back to me, I've sent a file via WeTransfer. 73 Niels, G8RWG

Even with my QDX running 2W, I use the waterfall.

Hi Niels, Send me an example of your file that produces an inverted spectrum in MAP65, and I'll look into what's needed to fix it for you. -- 73, Joe, K1JT

Dave, my idea is that without fake it or split mode the real frequency you are transmitting is the same you are receiving. I operate QO-100 with 2 radio, and I can (I have to) set both the

Sorry JP, You should study a bit more history of the WSJT to note that originally it was really only weak signal reception via EME. Transmit powers were mostly at the kilowatt range. 73, Reino OH3mA

Taking 50dB out of a 15-bit audio signal leaves about 5 bits for the D/A convertor.  It takes 4 bits to overcome quantization error so the 1 extra bit is not a lot of headroom and that would be peak

I don't. This is on the screen of a 10 year old Asus K55A laptop running Linux. I have the windows tiled so I can see everything I need to in real time and anything farther back is just a click

Weak Signal != Low Power Tx Weak Signal = Low level Rx WSJTX helps you receive signals from another operator that have lower SNR than other modes.  The other operator may be lost in the noise

When the transmission dropped out, how long did the drop out last? Was it for 2 seconds out of a transmit cycle or was it for multiple complete cycles? How many cycles? Fritz KG7JLN

I was only asking because Flex tells me 'fake it" is not needed ( there wording ) all I am asking for is to have the error window removed when I change to hound mode, since slicemaster wont keep it

Hi Mike If I turn RPORT GAIN down I see the RF power drop. It does not affect anything on the computer. The FTDX10 does not work with the settings you suggest using the USB audio, because it

So do you mean if you turn RPORT GAIN down you see the audio level in WSJT-X go down too? The goal is WSJTX power slider at full scale, Windows Playback at -3dB, and 25W into the rig set at 50W. 

Sorry Bob, but you are very wrong on this. Please read the manual, it's right there in section 1... 1. Introduction WSJT-X is a computer program designed to facilitate basic amateur radio

Yes, and I wish the developers had been sufficiently aware of LONG established operating practices for CW, SSB, and RTTY to know better than to call this "Split Mode" was dumb. Using modes other than

Dave, You may first take safety copies of those wsjtx_log.adi files, hi! Reino

In many radios, the audio level is part of a VOX that triggers the radio so if the audio is down in level, at the edges, then you might only key the radio intermittently compared to operation in mid

There is really no way for the audio to be affected by it's placement in the waterfall except when the signal is near a band edge of your if filters. These often are 50Hz to 2.5kHz. Those are the

Just checked...RPORT GAIN does work on my rig (MAIN version V01-09), when on USB with SSB MOD SOURCE set to REAR/USB. The transmit level seems about the same as on DATA-U. I have RPORT GAIN at 70