FT8 uses 8-FSK Modulation with 6.25 Hz spacing. It is not one discreet tone. Therefore, it would be impossible to ONLY use one tone at 1500 Hz to exchange information using FT8 on 60M or any other

This comes up often, the reason 60 meter frequencies have not been added as the rules for 60m access are different around the globe. Its up to the local use to insert those frequencies.

The RESET will update the entire Frequency Table ... this is also covered in the User Guide section 4.6 which states that RESET will return the table to the default frequencies.

You have to RIGHT CLICK in the LIST of frequencies. You'll then see a menu which gives you a list of options. Neil KN3ILZ On 2/19/2020 1:43 PM, Scott Millick wrote:

I will practice my whistle to stay on 1500.

According to the precise definition in the rules the entire 2800 Hz spectrum is NOT AVAILABLE! Only one frequency is permitted and that is 1500 Hz. No moving around, no spreading out, period. Applies

Hi, WSJTX ver 2.1 introduced UDP message id 15 - ConfigIn It allows a companion program to send a UDP message to WSJTX to change mode and set/reset other items. It does not allow you to change the

Then what we all need to do is start doing this, http://www.openculture.com/2013/03/speaking_in_whistles_the_whistled_language_of_oaxaca_mexico.html These people communicate by whistling tones that is

these are both already included in wsjt,(not via udp, but they must have cat setup ) in drop down menus, so I am curious what the reason for this request. or am I misunderstanding Dave Garber VE3WEJ

Re: 60m Be very careful about 60m in the USA. The spread of FT8 activity away from 1500 Hz may well be in violation of FCC rules. I received a warning that enforcement of this rule was going to start

On Wed, Feb 19, 2020 at 09:45 PM, Kai-KE4PT wrote: I don't know how to manage the Windows OS to force temporary real-time priority for WSJT-X, other than to temporarily stop antivirus and stop

On 2/19/20 4:00 PM, Scott Millick wrote: Start WSJTX Click 'File' Click Settings... Click Frequencies Next, hover your mouse over one of the ROWs under "|

As long as we're discussing the Frequency List, I noticed that doing the Reset does not provide the 60M Frequency for FT8. I've inserted 5.357 MHz in my List. There is a fair bit of activity

On February 19, 2020 at 5:17 PM K8BL BOB LIDDY < k8bl@...> wrote: SCOTT... RIGHT CLICK , THEN ON "RESET". - Bob K8BL

SCOTT...  RIGHT CLICK , THEN ON "RESET".   - Bob K8BL

Hi Gary, It's not so much about how good my computer is (they're all good, mine is at the low end of the scale), as it is about what's running in the background that steals focus away for

it does not say anything about update settings frequency and right click inside in the middle doesnt say anything about an update

Can you please add a UDP message (application -> WSJT-X) to change mode and band. 73.

Scott, You need to Right-click down in the actual list of frequencies. As you can see in the first graphic below, if you hover over the "word" Frequency in the title, you get a

Scott...  Right-click IN the Freq Table itself and a window will appear. GL/73,    Bob  K8BL