If there are designated FT4 frequencies for 160 - 6 meters, I'd appreciate someone posting them here as I don't have them all. Thanks & 73, Dick- K9OM

Just create different configurations. One for normal operation and one for fox/hound. Bruce K5WBM

Operator Error - for some reason I was not hitting the continue button. Thanks to all for straightening me out. Jim -Fuller

F2 will take you directly to the most recently used tab in the Settings page. 73 -Jim NU0C "Ken via Groups.Io" <m1slh@...> wrote:

Did you click CONTINUE at the yellow box that posts the last log upload time? 73 -Jim NU0C "Jim Fuller" <jfull550@...> wrote:

Is there a shortcut way to disable Hound mode after completing with the DX and going back to normal working? If not, could there be? 73 Ken M1SLH

Thanks for checking - glad to know someone found me there. But now I'm stumped -I just went into their OQRS system both through their QRZ page and through the OQRS tab on their webpage. Selected

I had the same thing... Someone here suggested I uncheck flatten, I unchecked it, and problem was gone... Try unchecking flatten. 73, and thanks, Dave (NK7Z) https://www.nk7z.net ARRL Volunteer

It looks like AGC action pushing up the noise floor... Strong signal pushes it down, background gets dark, weaker does not push it so far down, so you start to see the background, so it shows up as

Have some patience. DXpeds don't operate under the best of circumstances. I see 20m and 40m FT8 for your call in their OQRS system. Try again. 73 -Jim NU0C "Jim Fuller" <jfull550@...>

I see 2 FT8 QSO’s with your call, when I check their log. One on 20 and one on 40.

I have had 2 FT8 F/H qso's with 5I4ZZ well over 24 hours ago. In both cases I received a "RR73" but I have not shown up in their online log. I have sent a note to their pilot per their website but

If you switch your mode to RTTY you will be able to copy. Contest weekend. On 2/14/2020 3:17 PM, Jacques Pecourt wrote:--Only losers need rally caps.

Anytime I see weird looking waterfall, it's cuz I've got some filters turned on by mistake after switching modes. Check that all filters and AGC are OFF. 73, GL, Herb, WB8ASI.

If this happens on Tuesday and you are using Win10, it could be the weekly update messing with software. Sent from Yahoo Mail for iPad

Phil, Right-click in the Frequency Table and a window will appear showing what can be done. Very easy. GL/73,   Bob  K8BL   

Try turning the input volume down but also check that the correct input is selected especially if u have a microphone or camera

My mistake ! Inadvertently turned down the wrong button on the radio and was cutting down the frequency response to 12 or 1300 Hz. Thank you again. Jacques W2/F2YS.

Thank you for the reply Bill. 2600 Hz. The strange part is that this only happen once in a while and normally, without changing anything in the receiving mode I decode perfectly well from 200 to over

Check your radio filter setting. It should be the widest available for FT8.