Of course, you probably have to take the info down, and then go to the US site, Amazon.com Neil, KN3ILZ On 4/12/2020 10:46 AM, Neil Zampella wrote:

Bob, he's given you the link to the cables at Amazon, all you have to do is click on the link. Neil, KN3ILZ On 4/12/2020 10:32 AM, Bob McGraw - K4TAX wrote:

Please share where you obtained these and any other model/ spec information. Many of us could take advantage of this information. Bob, K4TAX

You could also only use cables that have chokes on them. These are what I use, no problems in my

Hi Ed, the most likely cause is RFI disrupting the USB connection between your rig and PC. Try using a different aerial, dummy load, or reduced power and see if that eliminates the

Icom 7300 Signal link usb win10 radio works on Fldigi and Digilink with soundcard setting used for wsjt x 73 Ed W8EO

What is this? This message appears randomly. I have read all the info on the Web about this and am no further ahead in addressing this. Sometimes the app works well but at other times this message

Solved! I had to go into settings>privacy>microphone access to allow access to the microphone.

Tom, it shouldn't so long as the pre-amp has lower noise than the band noise, and if is hasn't there's not much point to it. 73 Bill G4WJS.

Hi Bill One thing missing is the value vs time irrespective of mode, analog or digital. There is no hard definition on how to report the strength of a signal when it varies over time. On analog modes

Steve, Just a quick thought. Have you checked the Line Input level in the K3s Menu/Config settings. Irwin KD3TB -- Irwin KD3TB

It also depends on if the receiving station is using reception preamplifiers - and the other station not. 73 from Tom (LA4LN / LN1V) Sendt fra Outlook Mobile

NO FT4 in this contest! Only FT8. And NO WARC bands. On Sunday, April 12, 2020, 7:43:04 AM EDT, Dave_G0WBX via groups.io <g8kbvdave@...>

Uh.. Contest time again, stomping on other weak signal watering holes.  This time FT4 on the 17m WSPR slot.  (Must have been a RTTY op' in a past life.) 73. Dave G0WBX. -- Created on and sent

On 12/04/2020 01:48, M Lu wrote: Hi Mark, there are many ways to form signal strength reports, each has limitations. 1) S-meter, these are roughly relative to absolute

I worked YS1STAYHOM5 ok

Hi All, Setting up my K3S and I get an error message saying "Error in Sound Input An error opening the audio input device has occurred". Following advice from many of the posts here, I have the radio

Hi Mark, The reported S/N is affected by many issues. Your radiated power, receiver station local QRM, QRN and other noises on the band and propagation condition define the report you will receive

Not sure anything can be done other than truncating the callsign. There is only so much room in the data package that JT8 uses. Neil, KN3ILZ On 4/11/2020 8:43 PM,

I saw a chat awhile back that if the report you received was *stronger* that the report you sent to the other station, then there was something meaningful about that. But I can’t recall. I am