Thanks for the correction! 73, Jim

Jim The 2M TM-255A radio is an all mode rig. That incudes SSB too. I looked it up !! Marion, K4GOK On Fri, 24 Apr 2020 15:15:39 -0700 "Jim Brown" <k9yc@...> writes:

I'll take a look at that. I should have some time... we had a wicked thunderstorm last night and lightning took out my Cat port. Thanks for the info.

These radios will NEVER work with WSJT-X -- they are FM radios! Virtually digital modes (other than digital voice modes designed for VHF/UHF) require an SSB tranceiver. 73, Jim K9YC

Glenn I forget to mention..... when you insert the signalink USB into your computer it will automatically install the drivers. Check under your Device Settings/COM ports (you might want to check

Glenn I’m in the same boat with a Kenwood D-74 and FLDigi. I have a signalink on order. A brief review of their manual indicates that you should choose VOX. For the D-74 the jumper board I ordered

Have a 5-el at 85’ fed with 7/8” hardline and a 5-el side mounted at 45’ fed with ½” hardline. On 4/14-4/16 there was a slight edge on the higher antenna to the south. In the summer of 2018

Tnx. OK, I set-up 2M in the Settings > Configuration file. But, I do not have my radio in the "Rig" list. I have a 2M TM-255A radio. Any suggestions on what radio name to use. This is an old 2M

Thanks for the suggestion. Hiroki

Hi Dick do you have the “fast Graph” up when you are using the MSK144 MODE? ROBERT W6INO W6INO ~~~~~~~~~~~~~~~~~~~~~~~~~~~ Twenty years from now, you will be more disappointed by the things you

Check the "mode" on the radio... If it is set to CW or FM, for example, it won't let you tx digital like ft8 or wspr. 73 - John - N7GHZ

It would be nice to have a quick from distance visual indicator-- Anthony Luscre K8ZT Ohio Section Section Youth Coordinator & Education Outreach ARRL - The National Association For Amateur

On 24/04/2020 17:57, Anthony Luscre wrote: Hi Anthony, the different T/R period should be a good indication of which of those two modes is active. 73 Bill

Would it be possible to change color for mode indicator for FT4 so it would not be the same as FT8? This would provide a quick visual of the selected mode. -- Anthony Luscre K8ZT Ohio Section

On Tue, Apr 21, 2020 at 11:05 PM, Jim Brown wrote: .... "When you set up for MSK144, use AutoLevel a few times to set the "no signal" trace to a good level...."Good morning Jim I have looked through

Hiroki, the "Settings->Radio->Transmit audio source" controls are only made available for rig models where CAT commands determine where Tx audio is taken from. For rigs like your Icom the transmit

In my WSJT “radio” tab settings the “Transmit Audio Source” is grayed out and the setting is stuck on “Front/Mic.” It doesn’t allow me to switch it to “Rear/Data”. Does anyone have

When I selected 18.110 it changed for a few seconds and then Dave, Something like his has happened to me. It seemed to be a USB CAT fault, when I removed and replaced the USB it worked normally. WSJT

Hi David, something similar will happen if you insert a frequency into "Settings->Frequencies->Working Frequencies" that is not available on your rig, e.g. you may have put a frequency in using units

I have just had this strange behaviour.   But I have cured it after a restart (no effect) and a computer re-boot and second restart, System is PC - Win4YaesuSuite  - SCU17interface   -