The OP appears to be taking about a specific software-defined-radio and its firmware, and is probably better off asking in a forum for that particular radio to get it working properly, before trying

Some administrations do not even authorise the use of /QRP in their licences, including the UK. 73 Roger GWHZA

(Face palm) Switching the COM port did the trick. Thanks!

I don't agree but, my former question here was for using /qrp in wsjt-x and not a general question about it. 73

Hi Jason, Perhaps I am asking a silly question, but which program you are talking about? 73, Reino OH3mA

Hi Tad, Does it response with Tx1 (DX call your call grid) or continues sending Tx6 (the CQ message)? 73, Reino OH3mA

hI I uploaded version 1.2 Latest version when going through the calibration i am getting only 500khz instead of 1Mhz Anyone Had such issues. regards Jason 9H5BM

Change Handshake to "Default". Mike W9MDB

Used your procedure Fred and the software came right up using all the original 2.5.4 settings and without needing to go away from My FLex and HRD setup... Thank You, I was only down maybe an hour is

IIs anyone aware of a way that the WSJT-X software program can be set up in FT8 mode and used specifically for the upcoming Winter Field Day contest? Our group is planning to operate the event and

I don't know if this was discussed earlier due to crowded traffic here. Using the 2.5.4 Release with my old radio, Kenwood TS-450S. Each time I start the program, the frequency on the radio, which I

Thanks for the replies.... Just thought I'd ask!

And doing the polynomials to validate it as well <G>. Although they "look" the same on the waterfall the WSJTX decoder is marginally more sensitive on or very close to the RX offset. Getting the

I work a lot of QRP, but I never sign /QRP, and will never work station signing /QRP. I view it as asking for special treatment. 73, Jim K9YC

The first question was for the flex6600, not the FT-891. First, is the COM4 you are specifying correct? The COM designation for many Yaesu rigs is Enhanced instead of Standard, but Enhanced is usually

I've noticed the same thing, only recently. Sometimes when someone answers my CQ, I keep responding with my call and grid square, until I manually progress it toward signal report. For over a year

I have tried the updated dll (with both wsjtx version 2.5.4 and 2.6.0) both are giving me hamlib errors before and after the dll update. Screenshot of the error, post dll update:

G'day Nick. It should NEVER call CQ by itself and it should NEVER answer callers by itself and it should NEVER respond to CQs by itself. YOU have to click on the calls that you wish to work. The

I'm going to say "yes" simply because I hadn't touched anything. However, unfortunately, I've fixed it anyway by re-installing over the top. I will screenshot my working settings and next time it

Do you have call first checked? Bruce - K5WBM