Hi Bob The setup you sent me seems to work here also THANKS Chuck N6OJ On Thursday, May 7, 2020, 01:20:33 PM PDT, K8BL BOB LIDDY <k8bl@...>

Please don't flame me. I read the manual, but I have a question. Several of my friends and I are starting to use MSK144. I'm running V2.1.0 under Ubuntu 19.04 (because 2.1.2 won't work because of a

George, Is everything in your station properly bonded, all grounds bonded, and the station to those grounds? If not, that could explain why it was working before and isn't now. Often when we make

Hi Bob, I'm running Windows 7 Professional but I have a number of computers - a tower system, a laptop and a Raspberry Pi. I've tried running the WSJT on all of them but initially tried it on the

Thanks Bill, But the problem isn't setting power level, the problem is running WSJT causes both the S/W and the rig to hang. To recover, I have to restart the S/W and do a factory reset on the rig.

Chuck, Here is how to indicate a "Worked Before" Station. This will only show up concerning a Station worked before when they call CQ. I've done it by going to "Colors" in the the "Setup" section and

No problem and hope to finally QSO with you someday. Seems like I skip over you occasionally from Melbourne -- Brian Wilkins KO4AQF

That did it. Put the 6 characters in and it moved. Thanks for the tidbit, all. 73 John

Ah, yes. Standby. They've attached the wrong way round, but it's fairly obvious which is which. I've thrown in a snap of the antenna for good measure.

Don't see any pictures, but there should be a good common mode choke on the coax where it connects to the antenna so that the coax does not become part of the antenna, putting more RF in the

Understood on the zip. I will try an input my 6 characters and wait for the updates to see if it moves, thanks. 73 John

Hello Alan, I hadn't thought of using the dummy load. You are indeed correct. Two pictures, one on transmit FT8 into the DL at 100w, the second into my Titan DX 10m up on top of the house with reduced

Data transport is very different from radio control. Bluetooth is a lossy encode/decode process -- the encode cycle throws away part of the audio based on studies of what the ear won't miss on speech

Hi John, EL98dt is obtained from your ZIP code in your FCC recorded address. 73 Bill G4WJS.

Six character not digit From pskreporter.info “ the general tab, you should enter your callsign and your locator. Enter at least a six character locator as it marks your location on the map with

Enter in a six digit identifier in WSJTX. I believe it may be trying to derive from IP (just guessing) and you are closer to dt than ds. For example I am EL98pg and another identifier on other sites.

Hi George, here is some info I put together for my FT 991A and Win 10 I still get quirks occasionally but it does not involve resetting the radio. All the best, Jamie K6NGN

I pulled up pskreporter map and it has my location incorrect. Every piece of software I have running only reports EL98 where I am actually located at EL98ds but it has me at EL98dt22. I know there

You don't mention your OS, but there is a known issue with OS X on Macs where you need to use an aggregate sound device rather than the native USB sound device or it locks up the radio and the

John, that says very little about audio over Bluetooth other than by using a Bluetooth headset, such headsets have built in functionality to communicate with the adaptive