Hank, A Joe says (And he should know!) any soundcard will work unless it is actually faulty. An expensive one is not required, WSJT is only using a very small audio range. Expensive ones are useful

>When the "Show DXCC, grid and worked before" setting is selected in Settings-General, how does this show up in the Band Activity pane? I am not recognizing anything. The next step is to re-read

I should have said "to improve audio signal level above 2.5 kHz"

Hi Wayne, I also use USB mode on my K3 so I can use the equalizer to improve receiver sensitivity above 2.5 kHz Compression is set to zero 73 Frank W3LPL

You need to goto the "advanced" tab at top; then select field day & enter your class & section code... In your case 1D PA(?) During FD, it will show automatically as CQ FD (Your callsign) 1D PA since

hi Bill, The only reason I'm not using Data USB on the TS590s is simply because I have always just used USB mode. Its always worked fine . If you are going to customise audio equalisation then

Jeff, Double-check your frequency list & make sure it says 144.174 for 2m. Have a friend who added a couple of freqs. a couple months back, but fat-fingered the keyboard & fouled up the listing for

When the "Show DXCC, grid and worked before" setting is selected in Settings-General, how does this show up in the Band Activity pane? I am not recognizing anything.

I will be working digital mode during Field Day 2020 from my QTH. This will be my first Field Day digital mode effort. My club is conducting Field Day from a park and will cautiously be using SSB and

HI, here is my experience so far. Have upgraded 2.1.2 and installed the latest version of WSJT-X 2.2.1, my result is I have no decode? Not sure what is wrong as I have checked all my settings on the

Hi Joe, For me with just a laptop the profile is just right. By adjusting the 2 main split frames as they are I have no problem seeing and working on any band. Should the frames be split even more

I just loaded v 2.2.1. Everything works as expected except the CAT control for my IC-706mkiig on 2m only. I'm using FT8 and when I select any band except 2M it works perfectly. I checked and refreshed

I tried looking through release notes and the forum and didn't see anything specific here. This may be a stupid question, but I feel like I am having more success making contacts with 2.1.2 than I am

I recently found a similar, but different, problem with DAX and my Flex 6600M ... After sitting a while, when I transmitted and viewed my signal on the Flex panel panadapter, it showed that I was

On 6/9/2020 7:00 PM, Jim Shorney wrote: SignaLink. Maybe it sould be "you get what you deserve." Bob - wd6dod sorry Jim

Hi Joe other way around. the new computer/sound card is producing 1/3 # of decodes as the old computer/sound card. old sound card was discontinued (it was old) by soundblaster; got their newer one to

You get what you pay for... careyfisher@... wrote:

This document is a must-read. Thank you very much Jim. Some months back I purchased a gently used US100 via eBay based on the information you provided. Best 20 bucks I ever spent. It works very well

thanks Martin. 2 comments: - mine is set to "slow" - not Fast or Mid, the other 2 choices - there is no "off" choice. perhaps I should try "fast" per your comment. - BUT, same rig used regardless of

Really ??? Why make something more complex when its not necessary. Neil, KN3ILZ On 6/9/2020 8:53 PM, JP Tucson, AZ wrote: Virus-free. www.avg.com