Brent, Directly? That seems to say you are not using it in conjunction with a SDR program to process the IQ signals. 73 Alan G4ZFQ

Hi Jay, You need to copy your previous contacts from the prior installation in Windows PC to the current one. The needed file is wsjtx_log.adi and the file location is defined in the User Guide

Bob, This is in addition to the setup message I sent you for the K3. Line Out and Line In are on the rear of the K3. Line Out is the audio that goes to your microphone connection on your sound card,

Hi Rick, sorry for the delay on this reply. I can confirm that the WSJT-X v2.3.0 RC2 message_aggregator example application has a regression that stops it showing decodes in each client window. It is

Thanks Robie, That was about the only upgrade I did not make, to my K3. Figures, hi! 73 es DX, Bob/AA6VB

Bob, Unless you have upgraded the K3 with the KIO3B you will still have to use the line in/out in addition to the RS232 for CAT control. Robie - AJ4F

What mode are you using that takes longer than ten minutes for a single transmission? I know some of them are slow, but I have not seen anything THAT slow. And, AFAIK, all modern digital modes contain

Good evening, I recently installed WSJT-X and GridTracker on a Raspbery PI4. Any contacts I make new now show up as "Green" on the display, but QSOs I made prior to this installation from my Windows

Hi Art, Yes, there is an RS232 between the P3 and the K3 and an available (second) RA232 port on the P3 for computer control. From reading the manual it “seems” like it will work but I wanted to

Yes, in a way. I'm using a SoftRock RXTX Ensemble, which is controlled directly from WSJT-X via USB. The program knows the VFO tuned frequency and the audio frequency offset. I am communicating

Bob, I use a USB to serial cable to go between my computer and the K3 RS-232 port. In WSJTX you need to put in the info required for the K3. I don’t have a P3, but isn’t it connected to the K3 via

make sure 20m is in usb-data mode, and not lsb Dave Garber VE3WEJ / VE3IE

Enable TX controls what happens the next sequence. It is not immediate. To halt it immediately, hit Halt TX, or just hit Escape. Gary - AG0N

Thanks Neil, I’ll order the adapter cable and give it a try. 🤞🤞 73 es DX, Bob/AA6VB

I would think that if you can do that with other software, such as the K3 Utility, it would work with WSJT-X, since the K3 Utility also provides some command functions. I know I

Hello Digital People! I would like to get on FT8 with my K3/P3 combo and wonder if I can attach a USB to RS232 cable to the RS232 Jack in the back of the P3 and run CAT control of the K3 on

On Sun, Nov 29, 2020 at 05:42 PM, Jamie GOLLY wrote: That exactly what my thoughts were! Why would anyone uses signal link with an FT 991/A when the radio can take a USB directly. Because some

My understanding is that the ID requirements (at least in the US) are accomplished by simply transmitting your call within the digital format. (FT8, JT65, etc) Sec. 97.119 Station identification. (b)

My station identifies with every WSJT-X exchange. Can you specify when you are not transmitting your call using WSJT-X? Best regards, Kevin Potter k5vp

My understanding is that the ID requirements (at least in the US) are accomplished by simply transmitting your call within the digital format. (FT8, JT65, etc) Sec. 97.119 Station