Bill Use the ACLog export as ADIF function (I am assuming it has one as all ham radio loggers should) - take the logfile and copy it to wsjtx_log.adi (Use File - Open Log Directory to get the correct

Dick One simple check - don’t start JTAlert (no need to remove it just don’t start it) does the problem still happen? You don’t even need to work someone - pop a callsign in WSJT-X and then

Yes I can believe that, looking at some of the ones the system decoded.

I use JTAlert in conjunction with WSJTx. After working a station, WSJTx transfers that station's data into ACLog. All working fine, however on occassion JTAlert will indicate that I have worked a

Greetings All ! I hope your holiday season is going well. I am experiencing problems with my system since addinf JTAlert to my operations. I am using the following setup: -DELL E6510 Laptop running

1) there are much better interfaces than Signalink at not much more money. 2) If one wants to use an inexpensive sound card, it is very easy to build a one resistor, one transistor PTT circuit driven

Maybe for the 756Pro, but for LOTS of radios, the SignaLink represents a simple solution for FT8. Some rigs use CAT to turn on the front microphone which defeats the rear digital mode audio.

I run 20 MILIWATTS ...... .02 Watts on WSPR using a WSPRLITE powered by a USB Charger. I get reports from all over the world.. I need less power or an attenuator to even "see" how my beam's

Are you by chance running any other software or running WSJT-X via another application? I've seen cases where closing an application does not release certain parameters with other

Bill thanks, poor choice of words contact better choice would have been reception report of a beacon I do realize WSPR is one way communication to test propagation which was actually what drew me to

There are good reasons not to use a Signalink. Google. Bob - wd6dod On 12/27/2020 1:43 PM, D. Scott MacKenzie wrote:

Hi Martin, the "Pwr" slider is an attenuator, slid to the very top is is 0 dB (full power), which is where you should set it when adjusting settings. Once set up you may use the "Pwr" slider to make

On 27/12/2020 15:05, kelvin348@... via groups.io wrote: Hi Kelvin, the IC-756 series of rigs have Rx audio and Tx audio connections on the rear ACC socket. It sounds like you

Practice sessions and photos! See below. Please feel free to share this with your local club and other appropriate channels. Last year with FT contesting still being such a new thing we scheduled

Hi Skip, you haven't told us what rig you have or how it is connected to your Mac for audio and CAT control. Most rigs have a menu setting to adjust the audio line out amplitude. Get Rx working

Running OSX Big Sur. Parallels with Windows 10 pro installed. FT8 on WSJT-X works a treat. Trying to setup WSJT-X on the Mac itself and it is giving me fits. The graph shows a signal on the bottom.

The CAT for the 756 Pro does PTT. At worse, you do VOX. No reason to by a Signalink…

Just be sure that you have a way of doing PTT. The Signalink is designed to do PTT, an inexpensive USB sound card might not support PTT. Download manual for Signalink USB to see what I mean. The

Can try but only loaded the drivers last week so assume I am running current release. Thanks Ted. 73 Marty KC3PZX

Update Silicon Labs drivers??? Yaesu web site 73, Ted