David, if you have no CAT connection then you must select "Settings->Radio->Rig->None". For PTT I expect your interface uses one of the RS-232 signals RTS or DTR to key your rig, to use that you need

David, Then how can "Test CAT" be expected to work? PTT may use VOX or a COM port signal. If you want to use CAT then it needs to be setup correctly. 73 Alan g4zfq

Hi Joel You are right that my set up is not using cat control and I am having to change frequencies manually but the Ptt command is sent via the data din port on the back of radio, I know that the

I had a recent Windows 7 failure. I was able to save my data, but had to scrap Windows 7 and installed Linux Mint. I was able to install WSJT-X, but I am not able to gain rig control to my Yaesu

I questioned West Mountain about my problem above.. They referred me to this article which fixed my problem. Just thought I would put the link here just in case someone else chased their tails...

I'm using different hashtags now that I have the hang of this. I cannot get wsjt-x to see sound cards, and the com ports do not work either. I suspect this happened when a windows update came, but

Thanks Rip, the Transmit Audio Source is gray out so I'm not able to change that. I'll play around with the settings and see if anything allows me to change that. 73 de Kell

If I understand how you are currently setup this may explain your problem... CAT controls the frequency/mode control and PTT commands to the radio unless you are attempting to do it via VOX. VOX can

I've quit using 50275 because there are actually OPs that use JT65 in this world. I first found Q65 when I was monitoring 50276 JT65 as VK/ZL use it to work South America during their summer E season.

Bill I am not using it for cat control just the main tx and rx switching of the radio. I had the same set up on a windows 10 laptop which was on its last leg so I decided to move onto the pi but it

David, how are you expecting CAT control to work if you have no connection to the rig's CAT control port? 73 Bill G4WJS.

Bill I am using the 6 pin mini din for the data connection not the cat Din and I am having to use a USB adapter for the pi to connect the 3.5mm. The cat din is connected to my Atu and it does have an

David, I need some clarification, the FT-897 has two mini-DIN sockets, one for audio in/out and one for CAT, does your interface connect to both of those sockets? The Pi 400 has no audio in

Bill I am using the current version 2.3.0

David, which version of WSJT-X are you using? 73 Bill G4WJS.

Hi Bill, The rig is connected using a xggcomms sound card that connects from the 6 pin data plug and then plugs into the pi with a USB and two 3.5mm audio jacks.

David, you have not told us anything about how your rig is connected to you Pi fro CAT control. 73 Bill G4WJS.

Hi Deni, whenever new modes are added you must reset the working frequencies table to pick up any changes, "Settings->Frequencies" then right-click the Working Frequencies table body and select

Hi all hopefully someone can give me tips to go in the right direction. My issue is that I can’t get my radio to communicate with wsjt-x. When I press test cat it just keeps bringing up errors,

I agree, Chris, it's way too early to button down anything. (and we may end up with different freq for intercontinental DX and the typical random qso water holes) What we have done here, as part of