Hi Paul. Aside from all you have done and the other suggestions, try checking you "USB MOD Level" parameter. 73. Carl - WC4H

Hi Paul, check you have set up you Tx audio levels correctly, see this post for details: https://groups.io/g/WSJTX/message/5077 Note that you must choose a Tx audio offset around 1500 Hz when

With respect to voltage drop when it goes to transmit. The ICOM supplied power cables are TOO long, at least a metre or more. I asked the supplier if they did a shorter cable but apparently they

Hi Milos, thanks for your reply. It is interesting that the issue is not limited to Kenwood but also happens with Yaesu rig. I will claim the issue to HRD LLC and hope that they will fix

Gents, My supply is a 13.8V 30 A switcher, SEC 1235M. I have observed the voltage at the end of the new manufacturer supplied cable and it falls a couple of tenths of a volt on PTT. I have observed

Check your power supply & power line to the radio. In particular, the in line fuses can have some gunk. Scape the fuse leads & exercise the fuses in & out of the fuse holder. If the problem comes

Paul, Hmmm... what are you powering this radio with? AC P.S. or a battery? Does it have enough current capacity? What is the p.s. voltage in (stick your dvm on it & monitor it!) If it is running

All, I have TX and drive level adjustment. With the power slider on the RHS of the WSJT-X operating screen and the sound level adjustment slider I can turn the RF power up and down. I can lower the

Ah.....yes. Thank you. On 4/13/2020 4:58 PM, Dave Garber wrote:

Try running the HRD CAT program in the background, might help. -- 73 de Amir K9CHP ARRL, Emergency Coordinator (EC) Liverpool Amateur Repeater Club www.W2CM.org Radio Amateurs of Greater Syracuse

Bill, I'm running Gentoo.

perhaps you meant to send this to an aprs group???? Dave Garber VE3WEJ / VE3IE

Hi Bill, RIG: Yaesu FT-911 Cat Control: Serial Port: (The Enhanced Serial port of Rig) Parameters: Rate: 4800 Data Bits: Default Stop Bits: Default

Hi Milos, thanks for your reply. It is interesting that the issue is not limted to Kenwood but also happens with Yaesu rig. I will claim the issue to HRD LLC and hope that they will fix it. 73 and

It is very common on both FT4 and FT8. I have some callers start with a signal report and no initial call. It still works and they end up in the log. 73, N0AN Hasan

Hi Giuliano, thanks for that. What are the settings on the left hand side of the "Settings->Radio" panel please? 73 Bill G4WJS.

Hi Bill, My Rig is FT-911A. De Settings are: PTT Method: CAT Mode: Data/Pkt Split Operation: Rig VFO-A mode is correcly changed from previosly set (LSB) but not

Hi JT, well done! What Linux distribution are you using? 73 Bill G4WJS.

Hi Giuliano, what rig do you have, and what settings do you have in WSJT-X on the left hand side of the "Settings->Radio" panel? 73 Bill G4WJS.

Hi Hans, I am an HRD user also. My workaround is the opposite: I connect my FT-817 to WSJT-X directly. I just send logged QSOs to HRD Logbook. I use WSJT-X + HRD Logbook only for FT8. You can try to