Bill, Thanks for the suggestions I will tackle the task after dinner. But it sounds very hopeful! I will followup with you in a bit. Thank you! Howie WA2AGA

On 03/04/2020 22:07, Howard Kunkel wrote: Hi Howie, I'm not sure why you have chosen to reinstall the virtual COM port driver when you clearly have a problem with audio to

Full time no audio to IC 7300 after windows 10 update to version 1909, CP210x removed software driver and reinstalled. No help. Comports disappear next start up. Subsequent restarts and reboots

Hello All, First of all, let me say a heartfelt thank you to the development team of the WSJT-X software. I enjoy using it. Secondly, it is quite possible

The problem with this is that the motherboard sound chip is only available if something is attached to it. For audio output at least I have an hdmi monitor, but I have no mic connected for input. So

On 4/3/20 3:21 PM, Glen Jenkins WB4KTF wrote: Not true. Your WSJT-X will decode all stations within the limits of the 'Wide Graph' lower to upper frequency. You do

>I am finding that when I am called or answered by a station that my Rx frequency is not moving to their Tx frequency, thus I do not decode them. Glen, The decoding of an answering station is

Do you have the "call first" box checked? I may be mistaken but believe that is the only way you automatically go to the calling station's freq. Mike / W8DN On 4/3/2020 3:21

I am finding that when I am called or answered by a station that my Rx frequency is not moving to their Tx frequency, thus I do not decode them. Is there a setting that I am missing or is this normal

Rick, Try this, when Windoze changes the Default sound device from the motherboard device to the CODEC device go into the Sound properties setup and right click on the motherboard device and select

That makes sense, Al. I use a RigExpert TI-8 which, like the SignaLink-USB, is powered by the computer’s USB port. It doesn’t even have a power switch so it runs anytime the computer is powered

That applies to the com port driver only, the CODEC driver might already be installed on the PC or it downloads it from the Microsoft driver server. The com port driver from Icom is actually from

Windows believes it knows best and sets the last installed/activated sound device as default wether you like it or not. The 7300 sound device is not started until the 7300 is power up.

Here.... Pay attention to the "INSTALL 7300 DRIVER - BEFORE YOU PLUG IN RADIO!" -part... https://www.k0pir.us/icom-7300-wsjt-x-ft8-easy-way/ 73 - John - N7GHZ

"Thank you everyone. Maybe I did not make myself clear. Yes the IC 7300 has a built in sound card. In Windows the laptop speakers and mic are set as default.

Thank you everyone. Maybe I did not make myself clear. Yes the IC 7300 has a built in sound card. In Windows the laptop speakers and mic are set as default. Everything works fine until I start up

 Windows does an automatic Restore Point from time to time. You might be able to find one that lets you gat back to a working setup. Good luck de Marion, K4GOK On Fri, 03 Apr 2020 06:38:40

Funny...still laughing! Monty W3SB

Bill: You, sir, are a genius! I could not help smiling when I read the message below. I immediately tested your described behavior and found that my “brilliant” fix for my audio problems (just

Andy, thanks for the effort to assist. The jtAlert has been uninstalled and rebooted but no help with problem.