Could that be because you're waiting for 73 and the other station has moved on? 73 is not part of a contest exchange. When one station has copied RRR or RR73, the QSO is complete. On 73, most of us

The latest W10 update displays an icon indicating that “WSJT-x is using your microphone” when it is running. If you set W10 security settings to block programs from using your microphone then

On 28/02/2020 20:46, Richard White wrote: Hi Dick, ignore Tx problem s until you have Rx working satisfactorily. Are you seeing signals on the WSJT-X waterfall display?

Set up is: Lenovo lap top PC, Signalink USB, YAESU Ft-450D. I have used this set up combination since I started working WSJT-X 31 March 2019 with no problems. Four weeks ago the 450D went into TX

Hi Al, Thanks for another good idea. I did transmit with zero power, and 50 watts, and the problem persists. Regards, Curt

Curt, One further thought... Try transmitting with the PWR set to zero ( radio keyed but no rf out) and see if the high CPU load is still present.. Then I am out of ideas.. AL,

Hi Charlie, you can add extra CAT commands to the mode setting commands in the Omni-Rig .ini file for your rig. Work on a copy of the file so you can always refer back to the original.

Hi Steve, how are you keeping your PC synchronized with UTC? 73 Bill G4WJS.

Hi, I have been having this problem for a couple of months and I am really getting frustrated. WSJT-X will sometimes not decode (no Blue color on the Decode button) a cycle or 4. Sometimes it's the

Chuck, Thanks for all the suggestions. I operate QRO in lots of contest everything that goes into and out for my PC has ferrite on it. I can switch to plain FT-8 it works great so to me that tells me

Hi Al, Thank you for the response and advice. The high CPU usage occurs right at the beginning of the receive cycle, following a transmit cycle. You and I have experienced exactly the same problem,

Curt, I have observed that FT8 does not decode if the total CPU usage is high at the start of a receive cycle. In my case I had a logging program that had high cpu usage at the end

I found the problem. I installed WSJT-X on the laptop and everything worked fine, in that process I found that the USB cable that was plugged into the main computer was bad. I replaced it before I set

I have learned how to change the FT-991 .ini file in OmniRig so that it now changes mode to "D-U" correctly using the drop down band select in WSJT-X. I notice now that I often also need to change

Eli, User Manual section 7.4. Contest Messages shows supported contest messages and how to invoke those contents. In short File -> Settings -> Advanced, then select Special operation activity and

How do you modify the exchange from standard to contest format? Would like to try a contest, but don’t know how to set the exchange Tnx in advance. Eli, N6PF

Does CAT and PTT pass their tests? Are you using the correct COM port number? Are your Icom drivers up to date? Is your radio set to USB-D? Have you had any Widows updates recently? I bet you

I checked the tone and the 2x was checked. I turned it off and then tried a FT4 contact and it worked fine. Then tried calling several stations on FT8. NO luck. I'm going to install WSJT-x on my

Well I setup WSJT-x to work with just the IC-7610 The Radio settings are the same as above in the screen shot. Except Rig is now IC-7610 . It seems to be setup but it does not transmit a signal. I

Um ... you're not just on 4 frequencies, you'll have signals all over the bandwidth. What they are saying is that you should NOT just use simplex to answer someone, but work 'split' (which