Yes, I'm seeing the same thing. 73, Herb WB8ASI

Wsjt -> File -> open log directory Jim Bacher, WB8VSU wb8vsu@... https://trc.guru

I looked all over and cannot find the ALL file which I'm told keeps a record of you contacts. Can someone point me in the right direction on this mysterious, file ? Bill K2WH

On 10.140 MHz, FT4, in the top left corner of the waterfall the word Controls has a coloured horizontal line through it. It is only this frequency and mode. Is it an anomaly, does it have any

Be careful which one you buy as some they sell do not have the right chip in it pet Bill's earlier comment. Jim Bacher, WB8VSU wb8vsu@... https://trc.guru

I am going to Best Buy today to get a serial to USB cable.

I have the MFJ 1204 and it has no other connector. I am going to Best Buy today to get a serial to USB adapter. Bill W5EC

Hi Bill, comments in line below. Yes. The MFJ interface does not provide a CAT connection, it is simply a USB audio codec with built in VOX PTT switching. A USB to serial adapter is what you need,

OM, check you MS Windows microphone and camera privacy settings, it seems your WSJT-X is barred from accessing audio input

Rig and PC are connected via USB cable. I set "USB Audio Codec" as an input of FT8 signal. After Windows 10 was updated, WSJT-X no longer recognized USB Audio CODEC. FT8 signals don't enter WSJT-X.

Didn't see what MFJ interface you have. Some interfaces boxes have connection to go to your serial port on your rig, basically a built in USB to serial device. If it does you do not need a USB to

Hey Bill, Thank you for the reply. Do you mean a serial cable in addition to the interface unit? My Jupiter has a DB-9 serial connector but my computer does not. I have a DB-9 to DB-9 cable. A serial

Hi Bill, you need a CAT interface for CAT control of a rig. In your case I believe a USB to serial adapter will do, unless you have a real serial port on your PC, and that connects to the DB-9 serial

I am using the MFJ interface. With no radio selected, the rig is VOX activated.

Do you have a serial-to-USB cable going from the computer to the radio? Do you know the Com Port number that it has been assigned by the computer? If so, did you set that com port number in the

I need to clarify my "need help" post. I want to emphasize that I am wsjt-x beginner--1 week. When I downloaded the software I viewed several videos for ft8 beginners so I could get the setup correct.

Hi Markku, the latter, and you can simplify the steps required by creating a new WSJT-X configuration (Menu->Configurations) that has rig control disabled by setting "Settings->Radio-.Rig->None". If

All I have been trying to figure out how to use WSJT-X "correctly" to work JA from Finland (OH). As I can transmit at 1840 and JA station can't, I would like to fix the transmit F at 1840 kHz and use

Maybe RF is getting into your computer and causing the error message. Can you put some ferrite chokes on your cables, or at least transmit at very low power into a dummy load to see if the problem

You must start the contact to go into auto seq. It does not start without manual intervention. As far as I know sent by my LG phone