Will WSJT-X recognize "CQ SOTA N1RBD EM84" or "CQ POTA N1RBD EM84" as a valid CQ and treat it as such? I'd like to let people know when I call CQ that I am on a POTA/SOTA activation. Thanks

Hi Carl, On 18.10.2019 23.21, Carl Andreasen wrote:> I have been unable to install the newer versions of wsjtx on my Linux 18.3 system. Is this by any chanse a 'Linux Mint 18.3'

Here's an example that happened early this morning while I was trying to get the VK9NC Norfolk Island DXpedition on their first day. After 2 hours of trying to get through a huge pileup I finally got

I have been unable to install the newer versions of wsjtx on my Linux 18.3 system. It says I must have libc6 version >= to.... I have installed every libc6 module I can find but nothing changes. I use

Mmkm Sent from my iPhone

Colin, Yes, I was assuming you were asking about the Split Mode. So my reply was addressed to that question. I couldn't find any more information on using Hamlib with WSJT-X, so I don't think I can

Follow-up after another repair session: disabled broken onboard sound device in BIOS disabled SoundBlaster in device manager reinstalled WSJT-X works fine again using the cheap, external USB sound

Hello again Jerry, Justtried the settings and re read your email several times. I am not trying to use split mode so its a shame that we can not disable the option in WSJT or I guess

David: as far as i know there no set frequencies for F & H. Each DX expedition usually determines its freq. plan . Search for the exped callsign E.g. VP6R on Pitcairn Is and find there website

Possibly because this message is from January and my emails for this group only go back to June or so. I normally don't expect to see answers to 10 month old posts, so I don't go back forever looking

seeking a little info..... would like to know what the recommended frequencies for F & H mode by band ? all info appreciated for sure. david/wd4kpd

Thanks Jerry for the information. I am sure that I have tried all combinations of the settings but will try your suggestions. Colin G0ODR

Mike, This is the original thread I was replying to. I'm not sure why the link didn't show Many incomplete contacts Many incomplete contacts 73 Pat N6PAT

The watchdog timer is configurable. I believe it defaults to 6 minutes, but there's nothing keeping people from increasing it to, say, 60 minutes. 73, -- Dave Slotter, W3DJS

Watchdog must have been off and robot on....

I think that if you look carefully at the waterfall, the station you are trying to QSO with may look a little bit broader than normal and that it appears that your RX bracket is not centered. I see

Apparently I am not getting all the messages for this group. I cannot find the message this user is replying to. It makes it very hard to follow a thread when you only see part of the messages.

I had one last night, FT4 on 20m, with a K4 where he kept sending R -07 for TWENTY ONE minutes !! I kept responding with RR73 each time and finally got a 73 ... I've emailed him to ask what was

I am also seeing this same behavior. A DX station is calling CQ. I respond. He sends a signal report. I send send R-signal report. He keeps sending his initial signal report as if not hearing me even

Colin, I looked into the Hamlib interface for my Yaest FT-817 when I first started using WSJT-X to see if I could get Split Operation to work in the Rig mode. I came to the conclusion that there are