Thanks for your advice. What I did was to change the soundcard and change a few things with the TS-480. Evan KB2AMY

I can’t believe how many different Linux versions there are with incompatibilities all over the map. How does anyone figure out which app version works with which Linux version. Ubuntu, Fedora,

That's a Windows problem.

I can't believe how Microsoft make life so difficult for everyone. 73 Roger GW4HZZA

Hi W5EC (name?) The IC7300 is all set to go.  It's your computer that isn't. This requirement should be clearly shown in your IC7300 instruction manual. Larry / W1DYJ

To be clear, the Icom driver gets installed on your computer. If you running a PC. look at page 22 of the manual to start. https://www.icomjapan.com/lineup/products/IC-7300_USA/?open=4#manual

I can’t believe your computer didn’t come with the Icom (and every other esoteric USB device) driver preinstalled. 😁 Guess you should have gotten a Linux box after all, then your _radio_

I haven't, but I will today. I can't believe that a brand new radio doesn't come ready to play!

Did you install the Icom drivers? Mike W9MDB

Change WSJTX Reporting address to 224.0.0.1 You'll have to update ACL too.  JTAlert picks up the address automagically. Mike W9MDB

Mike, Menu 24 - 0 Hz Menu 25 - 10 (digital mic gain -- may need to be different depending on your digi interface) Menu 26 - USER-U Menu 27 - 0 Hz WSJT-X (and all other digi software) works as

Is there an FT-817 owner that can confirm the behavior of Menu 24 and 27 for User-U mode. VK9XX was on DXpedition as was transmitting 1500Hz higher than he thought and we're trying to find the right

Hi, I'm not sure where this should belong, so I'm asking for some advice here. I have win4Yaesu, WSJT-X, JT-Alert, ACL & GridTracker on my IBM PC. I am able to run successfully win4Yaesu, WSJT-X,

For several years I have been happily using my Ten Tec Jupiter with WSJT X. Since it was not capable of CAT, I had to select the radio as "NONE". This worked well for me. Now I am upgrading to the

Hi Kent, Have you tried turning off the receiver's AGC, and turning down the RF-gain to the point where the receiver's S-meter stays at zero, just before it will start to rise? (This must be done

I just checked my system and the WSJT-X level indicator showed 46 dB with the antenna disconnected. I am using an IC-706MKIIG with Signalink interface. The reading varies between 0 dB and 57 dB if I

Hi Ron, There are at least following entities that may affect to the received signal strength in wsjt-x: Your FT5000mp Microkeyer Sound card, especially when it contain analog gain setting Windows

And don't forget to sync your time. Only a 2.5s error is allowed to decode for FT8 and 1.0s for FT4. When you do decode, the DT column in the Band Activity window should show most decodes to be

You shouldn't need to place the mouse on the stream. When you start WSJT-X and select a band, as long as there are stations transmitting, and your radio is passing audio to the computer, you should be

OM, I get a lot of bright streams on the Wide Graph but there is no decoding when I place the mouse on the stream. Sometimes stations pop up on the screen. Is there a way to improve the decoding? My