We need to work this again Andy. I thought we had you fixed. You going to be around today for a debug session? Mike

Are they members of the "I cannot be bothered sending 73 but I still expect you to send me a QSL card brigade"?

Hi Paul, is "Settings->General->Display->Tx messages to Rx frequency window" checked? 73 Bill G4WJS.

Your not alone with this problem. Since upgrading to v2.i I get the error each time I start the program. "Rig Control error" Hamlib error: Communication timed out out when opening connection to rig

I am running WSJTx V 2.1.0 and have noticed that the rx window does has stopped showing my sent information during a QSO. Could be wrong but I thought that in past versions of WSJTx it did record my

Do you mean they are not showing up in the wsjtx_log.adi file? Do you have antivirus running? Have you put an exclusion on the AppData\WSJT-X directory? de Mike W9MDB

Using fox mode on dxpedition CY9C. About 20 percent of our RR73 contacts are not being logged. Both 2.0.1 and 2.1.0. Causing big problems. Need some help. Contact is k5dhy.ham@....

If you mean the last couple of days it's been pretty lousy for QSOs. I've had several not finish too most always -18dB or lower and they fade or I fade on them. de Mike W9MDB

After down loading the current issue of FT8 I have had numerous contacts without my contacts signal report to me. This was very seldom in the previous version. Anyone else having a problem with not

I stumbled upon the 4 rig version on the web. -- Bo W4GHV - since '54

I tried two new laptops with Mint 19.1 and no change. I still get the vfo error. Would be a terrible tragedy to have to use Windows. On 7/28/19 2:12 PM, mike wrote:

Does Retry then work? I have started getting this the last month or so whenever I cold boot my computer but Retry works. With me, I think it is a Window 10 thing. ____________ 73, Jim –

Just kidding Carl.... hi hi

I'm thinking you should be able to run FLRig to hook up to Win4IcomSuite and have WSJT-X use FLRig. de Mike W9MDB

Michael, I never heard of FLRig but appreciate the tip and will definitely take a look !! Thanks, Brad, N8GLS

On 01/08/2019 14:41, Charles Hein wrote: Charlie, please follow the instruction above I gave to copy the whole error message to the Windows clipboard, and then paste it into a

Check to see if your rig is in Split mode. If so, remove Split and retry. - 73 and good DX de Mike, K6MKF, NCDXC Secretary

Apologies for the delay, I've been away from the radio for the last couple of days. Here's the error message we are both seeing: Charlie (N4NVD)

Replace OmniRig with FLRig. You can run one FLRig for each rig and hook up most any software to it via direct (WSJT-X, FLDigi) or via rigctlcom (for software that does not know HRD is the only

Hi Carl, Yes, that would work just fine if I was only running WSJT-X, however my set-up is a bit more complex and revolves around my logging software and its ability to interface with multiple rigs. I