Thanks. -- --w8lvn--

Kent, I spoke to a tech at Tigertronics and he told me the same thing you did. Menu settings for items 29 and 30 won't keep the radio from transmitting. He also suggested a reset of the

Menu number 071 is different from my setting on FT-991A. My setting for menu number 071 is DTR instead DAKY. And my setting for PTT Method is DTR instead CAT. I hope this may be help you. Rick

Agreed on all counts. Several times I've been able to use it to get someone to look for me, and even to suggest a clear frequency on his end. And yes, the only legit uses of ANY non-radio

Your request would be a lot easier to fulfill if JTAlert supported advanced platforms and not just Whinders . . . . Non-portable software is a complete non-starter in my world (and that of many

Bill The inline picture was relegated to an attachment which was garbled on Linux but OK in IOS.  In case you need it here is the text of the deb dependencies The following additional packages will

Bill That's interesting.  Ubuntu 22.04 definitely has libboost 1.74 :- I'm in the process of building a VM to test the deb. Rick (GM4JIB)

Having an issue here with setting up an ICOM IC-761 to work with WSJTX. It will not let me set the CAT control for PTT. I thought I had it working at one time before and then switched to using a

I want to advocate for more use of the Messaging app in the JT Alert companion program for WSJT-X. Right now, I'm watching 4X4ZP on 30 meters with a workable -15 dB signal into North America at 0120

Hi Bill I installed the deb using apt on a clean install of Ubuntu 22.04.1 LTS plus current updates.  Worked no problem. The dependencies that had to be installed were:- Note the boost file

There are several reasons without audio or no output. Make sure the followings: 1.Your send frequency by WSJT-X whether 1400Hz-1600Hz or not? 2. MENU NUMBER 64 and MENU NUMBER 65 in FT-991, Both are

In the referenced issue, I contribute the wide signal to several operator related factors.  The ham is a relatively new with a Technician grade license.  He does not have much, if any, electronic

A fairly simple way to check your own transmissions is to watch your output on an SDR. Just using one with no antenna or a very short piece of wire will fo the trick. -- John P. WA2FZW

Tom, Start here, Open Device Manager and click on the arrow for the Human Interface Devices, double click on every one for their properties. Click on the Power Management tab, if it is checked where

Make sure the USB device has Power Mangement turned of in Device Manager. Mike W9MDB

Digital and RTTY Dan KC2STA -- Dan Ziolkowski KC2STA SKCC #4290T Ubuntu LINUX

In this case, the fundamental signal was at 2000 Hz.  Fortunately the SSB filter in the radio would not pass the harmonics thus there was not an observable 4 kHz or 6 kHz signal.   The cause was

Is this for digital only? Tnx, Earl KD5XB yahoo.com@groups.io> wrote:

Ken - My interpretation of Initial Set Mode Item 30 is that HSEND is active regardless of the setting. If the radio is on any of the HF bands, Signalink should key the radio if the internal jumpers

Karl, The SL was ordered for for the IC-706 and has worked recently. Please verify these changes to the settings in the IC-706: menu # 29 - 1200 menu # 30 - off any others? are these