There are several reasons without audio or no output. Make sure the followings: 1.Your send frequency by WSJT-X whether 1400Hz-1600Hz or not? 2. MENU NUMBER 64 and MENU NUMBER 65 in FT-991, Both are

In the referenced issue, I contribute the wide signal to several operator related factors.  The ham is a relatively new with a Technician grade license.  He does not have much, if any, electronic

A fairly simple way to check your own transmissions is to watch your output on an SDR. Just using one with no antenna or a very short piece of wire will fo the trick. -- John P. WA2FZW

Tom, Start here, Open Device Manager and click on the arrow for the Human Interface Devices, double click on every one for their properties. Click on the Power Management tab, if it is checked where

Make sure the USB device has Power Mangement turned of in Device Manager. Mike W9MDB

Digital and RTTY Dan KC2STA -- Dan Ziolkowski KC2STA SKCC #4290T Ubuntu LINUX

In this case, the fundamental signal was at 2000 Hz.  Fortunately the SSB filter in the radio would not pass the harmonics thus there was not an observable 4 kHz or 6 kHz signal.   The cause was

Is this for digital only? Tnx, Earl KD5XB yahoo.com@groups.io> wrote:

Ken - My interpretation of Initial Set Mode Item 30 is that HSEND is active regardless of the setting. If the radio is on any of the HF bands, Signalink should key the radio if the internal jumpers

Karl, The SL was ordered for for the IC-706 and has worked recently. Please verify these changes to the settings in the IC-706: menu # 29 - 1200 menu # 30 - off any others? are these

See pages 6 and 35 of the IC-706MkII-G manual for wiring to the radio's ACC connector. Be SURE that your 13-pin DIN cable connector is properly wired for Icom, NOT Kenwood! Trust me, I have both

Went thru the same thing a few days ago with rig keying but no output, uninstalled WSJTX and reinstalled with the same problem. Finally figured it out, the daughter had audio muted on the laptop,

I have a semi-weird problem with my XIEGU X6100 transceiver. I have been using the XIEGU G90 on FT8 - (I had to use FLRIG to control the G90 with WSJTX). It has been set up using the XIEGU CE19 and

Mike, The SL was ordered for the IC-706 with the proper cable and chip. It had been working until my friend changed a setting somewhere that caused the problem. I'm going to have him change the

I get the boost error when installing the .deb on ubuntu 22. Unclear what to install go get this to work. -- --w8lvn--

What hamlib to you have on the Linux box? For Windows WSJTX comes with the latest hamlib. Linux will use whatever you have installed. This will tell you rigctl --version Mike W9MDB

If he is using the 13 pin cable, check the plug to confirm that it is connected/inserted correctly. It is possible to insert it "upside down" (rotated 180 degrees) which will cause the symptoms

That's what I like more than anything about this hobby; fellow hams are ready to share all they can to help out guys like me that get hung up. GREAT BUNCH OF PEOPLE!! Thanks to all of you for helping.

Did you wire the Signalink yourself or use on of their prewired chips? Mike W9MDB

UPDATE Correction After the latest phone call with my friend I have found the Signalink PTT light turns on but the radio does NOT go into transmit. I have been chasing an audio problem when it's