I confirm the error exactly as described. when it must read 7.000 MHz it reads 7,000 MHz and that makes it impossible to use it. Keeps happening since more than a year in all wsjtx versions until the

By non-trivial answers I meant things like "did you check the right COM port?" In any case, these are the CI-V settings for both of my IC-9700s. I remember that one works perfectly with WSJT-X

Please try this DLL....I just made a change that should help this.... https://www.dropbox.com/s/7aejdv74nfjxr0q/libhamlib-4.dll?dl=0 And if it still is wrong (which it likely will be) please provide

Without knowing what settings you have already set, it's difficult to know what is "nontrivial" and you suggest you've tried everything already, so again, it's difficult to help without appearing to

FT-747GX is fixed at 4800,N,8,2 ... there is no option to change any of that. 73, ... Joe, W4TV

for what it's worth; I saw an earlier post about hearing voices on FT8: I had the same issue. i was also using grid tracker I turned off voice with alerts and it went away. so I would try that if

Yes I have. I sum up the situation: 3 radios: IC-7300 IC-9700 "Local" IC-9700 "QO-100" all connected with the same pc IC-7300 and IC-9700 "local" matched with WSJT-X Ic-9700 "QO-100" not. I compared

I think a few have reported an issue, but am not aware of (nor have I seen) any change in that area . .. -- Sent from my Android device with K-9 Mail. Please excuse my brevity.

Do you have separate configurations in WSJTX for the 7300 and 9700? I have the same two rigs working well with WSJTX this way. Dennis, N1RDN

I thought that, in the latest versions, the power slider isn't connected anymore?

A couple of quick things to try...Try using 1 stop bit. Failing that, try a slower baud rate. 73, Dave - N5DCH

Proper ALC level depends on the rig.  Some want zero...some want a bit of ALC in order to get maximum (not full) power. You have to know your ALC's behavior.  One way to tell is pretty easy. Set

Occasionally (once every few dozen tries, perhaps?) after I use Halt TX to stop an unwanted transmission, the next time a message is transmitted there will be no audio; the rig is switched into TX,

I've had this issue for a couple of years now. I think it is a known bug. It has happened with each update of the program here. The solution? Quickly hit Halt TX, then Enable TX. 99% of the time this

If you are running with ALC showing then you could be over driving your audio anyway.

Hi Bob, nope. I occurs using WSJT-X and watching my monitor. Saving is switched of on my monitor. 73 Alex

Hi, It could be you have an HDMI monitor and this can cause this problem. There are several threads on this on the forum. If you think this may apply to your set up, change settings to stop the

I'm trying to setup CAT to control my rig; my settings are: COM4 8 data bits 2 stop bits no handshake other pins on default The Test CAT button works, it sets to green, and PTT also correctly starts

Thanks to everyone. All is in order again. I rely on Gridtracker for my stats and it lost track of most of my states. Reinstalling it found everything. GT must maintain it's own DBs for stats.

Hi Joe, The 440's ATU is only good to about an SWR of 2:1. I have a Yaesu FC301 manual tuner with an 80-10m Off Center Fed Dipole, and works great. Good up to 300W. They aren't made anymore, but