Thanks,Bill. I'll give it a try. 73 de Jim - K9dd

Bins/Pixel. de Mike W9MDB

Is it possible to adjust the frequency span independently of the window width? I can't seem to do it. 73, Roger

No, never saw that in any U-tube instructions or anywhere mentioned on Yaesu group. But thanks, and I'll give it a try. You have been most helpful in steering me in the right directions. Thanks

Thanks Mike.......will adjust. Knew it was way off, but was trying to follow the instructions advice, and wondered what I was missing.

Also...if you're hooking up a speaker output to a MIC input that's a speaker level signal into a mic level input. You're over driving the heck out of it and that's a very common source of harmonics

For the USB audio did you set menu 103 to DATA? Mike

set menu 079 to zero, and still blasting ALC with PWR slider at bottom. You got me on the right track tho. I can crank down on the sound card, but the instructions said 0db which is the max. I

In which case you probably want the MIC level adjustment menu 079 I figure you were using the USB. de Mike W9MDB

Thanks Detective Mike........I didn't mention I'm running a FTdx5000, but menu 070 doesn't help even set to zero. I have audio running from computer via cable into rig via rear MIC jack, and from rig

Go to menu 070 and turn it down. You can likely crank the Pwr slider all the way up with menu 070 being the adjustment you need to make. de Mike W9MDB

Mix 31 is the common one you'll find. https://palomar-engineers.com/ferrite-products/ferrite-cores/ferrite-mix-selection de Mike W9MDB

To Bob KD6C, Might you have the mix# of the toroids used? 73 jerry km3k Sent from my Samsung Galaxy smartphone.

Thanks Bill, I've just spent the last few days changing from a Windows 7 32-bit PC to one that's WIndows 10 64-bit including upgrading to WSJT-X v2.1.0 and JTAlert 2.13.10, while bringing along my

Hi John, it's good that the DAX devices will not add digital gain. VAC can but also can be disabled in that case. You should get exactly the same power output between the 32-bit

Ø The Windows mixer control behaves differently with the 64-bit version of WSJT-X, it is no longer controlled by the "Pwr" slider in WSJT-X. You must adjust it manually which should be a one time

you do know that ft4 is only a 6 second transmission cycle, not 15 seconds. is that what you are observing? Dave Garber VE3WEJ / VE3IE

you are not using the internal audio codec, within the 590?? if the driver is installed, even if you are not using it, make sure you selected the correct audio codec input. Dave Garber VE3WEJ / VE3IE

Hi Jim, there's nothing wrong with having the "Pwr" slider all the way up, that should be your default starting place when adjusting the Tx audio levels. The Windows mixer

I installed version 2.1 and now when I transmit or tune I have to move the Pwr slider nearly all the way to the top to get the correct output. The levels control in the mixer no longer changes the